H1->H2->H3->H4->H5->H6. The indicator lights
show the selection (see below table).
Water hardness
°dH
Mmol/l
0 – 5
0 – 0.94
6 – 11
1.0 – 2.0
12 – 17
2.1 – 3.0
18 – 22
3.1 – 4.0
23 – 34
4.1 – 6.0
35 – 55
6.1 – 9.8
°dH: German degree of hardness
Every cycle with a regeneration operation consumes additional 2.0 liters of water, the energy consumption
1)
increases by 0.02 kWh and the program extends by 4 minutes.
Fill with salt
CAUTION:
• Only refill the salt container when the salt warning
lamp is lighting.
• During filling the salt container, salt and water can
escape. Start a program immediately after you
have filled the container to prevent corrosion.
• Remove the lower basket and unscrew the lid of
the salt container.
• Add about 1.5 kg of salt by using the supplied
funnel tube.
• Full fill the salt container with water (just before
the first use).
• Screw the lid firmly on again after filling the con-
tainer.
• Depending on salt resolution, the warning lamp
usually disappears immediately after filling.
Regeneration occurs every
Setting
H1
H2
H3
(factory setting)
H4
H5
H6
• The setting will be saved automatically after a few
seconds; alternatively, exit the setup via the pow-
er button.
X program sequence
1)
No regeneration
10
5
3
2
1
B. Fill the rinse aid dispenser
Function of rinse aid
The rinse aid is automatically added during the final
rinse, ensuring thorough rinsing and a spot and
streak free drying.
When to refill the rinse aid dispenser
optical level indicator (D) next to the dispenser.
When the rinse aid dispenser is full, the indicator is
completely dark. If the rinse aid diminishes, the size
of the black dot changes as shown below. To avoid
spotting, the rinse aid level must not drop below ¼.
full
Fill in the rinse aid
33
Indicator light
lights brightly
ECO
ECO
ECO
If the corresponding message
does not light up in the display,
you can estimate the amount
of remaining rinse aid to the
¾ full
½ full
Salt consump-
tion / cycle
0 g
9 g
12 g
20 g
30 g
60 g
¼ full
empty