2.6.6 - Filling the plant
Remove the cap in order to operate on the intake line
cock and on that of the liquid which, on opening, allow
the appliance to be filled with refrigerant.
• Look for an adhesive sheet with 2 stick-
ers in the outdoor unit documentation.
• Remove the lower label and stick it in
proximity of the loading and/or reset point.
• Clearly note the amount of refrigerant
loaded on the refrigerant label using
indelible ink.
• In box "1" note the amount of gas
established in the technical data (kg).
• In box "2" note any additional load inserted
by the installation technician (kg).
• In box "3" the sum of the two previous
values (kg).
• Remove the transparent label remaining
in the upper part of the adhesive sheet
and stick it over the previous one affixed
to the loading point.
Avoid the emission of the fluorinated gas
contained here.
• Make sure that the fluorinated gas is never released into the atmosphere during
installation, assistance and disposal.
• Whenever a fluorinated gas leak is detected, the leak must be found and repaired
as quickly as possible.
ONLY qualified personnel must provide assistance on this product.
Any use of fluorinated gas in this appliance, e.g. during manual movement of the
product or re-loading the gas, must be compliant with the regulations regarding
determined fluorinated greenhouse gases and any applicable local laws.
2.6.7 - Connection of the condensate drain line
Connect a drain pipe, of appropriate length, to the indoor unit condensate drain pipe, and block it with a strap.
Make it run inside the duct parallel to the system pipes, fastening it to the same using straps.
Do not tighten the straps excessively in order to prevent damage to the insulation of the
pipes and narrow the drain pipe.
Where possible, make the condensate liquid flow directly into a rainwater gutter.
GR A
-
φόρτ
-
B
-
A
B
A
B
plaque
A B
, και +
A B
kg
1
kg
2
kg
3
B
A
EN - 15
ALYAS E INVERTER