Main Parts; Installation; Preparation; Checking The Contents - Puqpress Mini Bedienungsanleitung

3.3

Main parts

��
See for an overview of the main parts of
the Mini.
��
See for an overview of the main parts of
the Q1.
��
See for an overview of the main parts of
the Q2.
��
See for an overview of the main parts of
the Mini/Q1/Q2.
1. Tamper base bolt
2. Upper clamp
3. Tamper base
4. Contactless sensor
5. Lower clamp
6. Lower clamp bolts
7. Ground coffee basket
8. Display
9. Up button
10. Down button
11. Set button
12. On/off switch
13. Power cable port
14. Adjustment wheel
15. Power cable
16. T-wrench (10 mm)
17. Allen key (4 mm)
4

INSTALLATION

You have received your PUQpress in
operating condition. Now you only need to
adjust the port-a-filter and switch on the
PUQpress. Refer to the chapter 'Safety
instructions' for more information.
4.1

Preparation

4.1.1 Checking the contents

Check that all parts are present and that no
damage is visible on the parts. If parts are
missing or damaged, contact your dealer or
your authorised customer service centre.

4.1.2 Tools and materials

Required tools and materials
• Port-a-filter (group handle)
Provided tools and materials
• T-wrench
4.2 Adjusting the port-a-filter clamp
The PUQpress is designed so that all
different port-a-filters from various
espresso machines fit into the clamp for
even and level tamping.
CAUTION
6
Always adjust the lower clamp before use.
Not doing so results in exposure of
dangerous moving parts.
NOTICE
Make sure to adjust the lower clamp before
use. Not doing so can result in uneven and
unlevelled tamping.
1. Slightly loosen the bolts of the lower
clamp. Use the provided T-wrench. ��
2. Mini/Q1: Pull down the lower clamp. ��
Q2:Rotate the adjustment wheel
13
EN EN