Reasonably Foreseeable Misuses; Avoiding Misuse - Optimum OPTIsaw SD 500AV Betriebsanleitung

INFORMATION
The metal band saw with frequency converter is built according to the standard EN61800 class
C2.
WARNING!
Class C2 (machine tools) is not intended for use in residential or mixed areas where the
power supply is provided by a low-voltage public power supply system. In these areas it
may possibly be difficult to guarantee electromagnetic compatibility due to lead bound
as well as emitted interferences.
Overview of EMC categories:
Categorie C1
required limit values Class B Group 1 according to EN 55011

Categorie C2
Required limit values class A Group 1 according to EN 55011, Installation by EMC

expertsand warning: "This is a product of category C2 according to EN 61800-3. This
product may cause radio interference in a residential area. In this case, it may be necessary
for the operator to take appropriate action."
Categorie C3
Required limit values class A group 2 according to EN 55011, whereby these limit values

are below those of class A group 1, plus warning: „This type is not suitable for connection to
a public low-voltage network supplying residential buildings. When connecting to a public
low voltage network, radio frequency interference is expected. "
This machine
Categorie
Environment
Voltage / Current
EMC knowledge
WARNING!
Extremely severe injuries.
It is forbidden to make any modifications or alternations to the operation values of the
metal belt saw! They could endanger people and cause damage to the metal belt saw.
1.5

Reasonably foreseeable misuses

Any other use other than that specified under "Intended use" or any use beyond the described
use shall be deemed as non-intended use and is not permissible.
Any other use has to be discussed with the manufacturer.
In order to avoid misuse, it is necessary to read and understand the operating instructions
before first commissioning. Operators must be qualified.
1.5.1

Avoiding misuse

Use the correct metal saw bands, tooth pitch, depending on the material to be sawed.

Correct belt speed and feed depending on the material to be sawed.

EN
SD500AV
70
C1 C2
Residential area
Business area
Industrial area
< 1000 V
no requirement Installation and commissioning by an EMC expert
Translation of original instruction
C3 C4
Industry
> 1000 V
Version 1.0.6 - 2022-02-25
Safety