4 Pairing the radio module of the CEREC MC XL milling unit with the CEREC AC acquisition unit
6
Installation Instructions for Pairing the Radio Modules HW8614/F2 and HW8612/F2 CEREC AC
4
Pairing the radio module of the CEREC MC
XL milling unit with the CEREC AC
acquisition unit
✔
Pairing the radio module of the CEREC MC XL milling unit with the CEREC AC acquisition unit
A radio module 8614/F2 with power supply is connected to the
CEREC MC XL milling unit and the mains.
✔
A radio module 8614/F2 is installed in the CEREC AC acquisition
unit.
✔
The acquisition unit is switched on and the operating system has
booted up.
✔
The program "SubsControl" has started (see "Installing the
supplied programs [ → 5]").
1. If the program "SubsControl" has not started, insert the installation
CD and start the program "Setup.exe". Follow the instructions on
the screen and click "Next", followed by "Install" and "OK", until
the program "SubsControl" is started.
2. In the window for the program "SubsControl", click the "Start
subscription mode" button.
The radio module installed in the acquisition unit is configured for
the base station.
Sirona Dental Systems GmbH
62 80 064 D 3492
D 3492.031.02.02.02 06.2012