Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Cleaning and maintenance
The equipment does not require special maintenance. The
equipment does not require recalibration when it is assembled, used
and serviced according to the instructions.
⚠ WARNING
• Before cleaning and maintenance, remove the mains plug from
the wall socket.
• Do not use solvents to clean the equipment.
- Clean the equipment with a soft, absorbent cloth after each use.
- Regularly check that all screws and nuts are tight.
Defects and malfunctions
Despite continuous quality control, defects and malfunctions caused
by individual parts can occur in the equipment. In most cases, it will
be sufficient to replace the defective part.
- If the equipment does not function properly, immediately contact
the dealer.
- Provide the model number and the serial number of the equipment
to the dealer. State the nature of the problem, conditions of use
and purchase date.
Troubleshooting
Despite continuous quality control, defects and malfunctions caused
by individual components may occur in the equipment. In most cases
it's unnecessary to take the whole device in for repair, as it's usually
sufficient to replace the defective part.
If the equipment does not function properly during use, contact your
Tunturi dealer immediately. Always give the model and serial number
of your equipment. Please state also the nature of the problem,
conditions of use and purchase date.
If you require spare parts, always give the model, serial number of
your equipment and the spare part number for the part you need.
The spare part list is at the back of this manual. Use only spare parts
mentioned in the spare part list.
Error codes
If the display shows an error code
(marked with "E" + number), restart the equipment and check
whether the display still shows the error code. If the display still shows
the error code, immediately contact the dealer.
Transport and storage
⚠ WARNING
• Carry and move the equipment with care.
• Move the equipment and carefully put the equipment down.
• Place the equipment on a protective base to prevent damage to
the floor surface.
• Move and lift the equipment carefully over uneven surfaces.
• Do not move the equipment by grabbing the pedals, but use the
assigned handle on top of the housing.
• Store the equipment in a dry place with as little temperature
variation as possible.
Additional information
Packaging disposal
Government guidelines ask that we reduce the amount of waste
material disposed of in land fill sites. We therefore ask that you
dispose of all packaging waste responsibly at public recycling centres.
End of life disposal
We at Tunturi hope you enjoy many years of enjoyable use from
your fitness trainer. However, a Time will come when your fitness
trainer will come to the end of its useful life. Under 'European WEEE
Legislation you are responsible for the appropriate disposal of your
fitness trainer to a recognised public collection facility.
Technical data
Parameter
Unit of measurement
Mains voltage
VAC
Mains frequency
HZ
Speed
Levels
Length
Cm
Width
Cm
Height
Cm
Weight
Kg
hand-grip contact
Heartrate
5.3~ 5.4 Khz.
measurement
available via:
Bluetooth (BLE)
ANT+
Declaration of the manufacturer
Tunturi New Fitness BV declares that the product is in conformity with
the following standards and directives: EN 957 (HC), 2014/30/EU .
The product therefore carries the CE label.
08-2021
Tunturi New Fitness BV
Purmerweg 1
1311 XE Almere
The Netherlands
Disclaimer
© 2021 Tunturi New Fitness BV
All rights reserved.
- The product and the manual are subject to change.
- Specifications can be changed without further notice.
- Check our website for the latest user manual version.
1 3
GB
Value
210 ~ 240
50 ~ 60
1 ~ 15
42.0
40.0
29.0
4.5
Werbung
Inhaltsverzeichnis
Fehlerbehebung
