Auto Power Off - Roadstar PCD-498NMP Bedienungsanleitung

Cautions:
• DO NOT mix rechargeable (Nickel-Cadmium) and regular (Carbon-zinc) batte-
ries.
•
DO NOT charge continuously for 24 hours or more, otherwise it will deteriorate
the performance of the rechargeable batteries.
•
DO NOT try to recharge normal (not rechargeable) batteries. They can explo-
de!
Notes:
•
If the rechargeable batteries are being charged for the first time, it will take ap-
proximately 15 hours to be fully charged.
•
If the operating time decreases drastically even when the rechargeable batte-
ries are properly recharged, purchase a new set of rechargeable batteries.
AUTO POWER-OFF
When the unit is stopped for approximately 30 seconds, the Auto Power Off function
will activated and turn the unit off automatically.
CD-MP3 OPERATION
1. Connect your earphones into the [HEADPHONES SOCKET] (11);
2. Press [OPEN] (8) to open the [CD DOOR] (9) and place a CD with the label up in
the CD compartment;
3. Close the [CD DOOR] (9);
4. Press [PLAY] (2). Focus search is performed and playback will start automati-
cally from the first track;
5. Adjust the volume with the [VOLUME KNOB] (10) to the desired level;
6. To turn the unit off, press the [STOP] button (3) twice.
Note:
•
Press [PLAY-PAUSE] (2)to play. When it plays, press to stop playback tempo-
rarily and press again to resume playback.
•
Press [STOP¨] (3) when you want to finish playback. Press twice to switch
OFF the unit.
• Press [SKIP -] (4) to go to the previous track, press & hold to go back fast.
•
Press [SKIP +] (5) to go to the next track, press & hold to go fast forward.
PROGRAMMING
Up to 99 tacks (MP3, 20 in CD) can be programmed and play in any order.
1. Stop the playback by pressing [STOP] (3);
2. Press [PROGRAM] (6), the display (1) will show the number of the track
on the left side and the number of program on the right side.
3. Select desired track by using [SKIP -/+] buttons (4/5);
4. Press [PROGRAM] (6) to confirm desired track into the program
memory;
5. Repeat step 3 and 4 to enter additional tracks into the program memory.
6. When all the desired tracks have been programmed, press [PLAY] (2) to play the
disc in the order you have programmed.
Note: Press [STOP] (3) to terminate programmed play.
English 2