Fitting The Indicator On The Cutting Limit; Fitting Of The Battery Backpack (If Available); Controls; Safety Button (Activation / Deactivation) - Stiga LT 500 Li 48 Gebrauchsanweisung

Every cutting means must
be fitted with a specific guard, as
indicated by the following directions
in the Technical Data table.
1. Place the guard (Fig. 5.A) on the holes
on the power unit base (Fig. 5.B).
2. Secure the guard (Fig. 5.A) fully
tightening the screws (Fig. 5.C).
NOTE On the guard of the cutting
means there is the following symbol:
4.5 FITTING THE INDICATOR
ON THE CUTTING LIMIT
– Insert and fasten the two ends of the cutting
limit indicator (Fig. 6.A) in their respective
holes on the power unit (Fig. 6.B).
4.6 FITTING OF THE BATTERY
BACKPACK (IF AVAILABLE)
The battery backpack is delivered already
assembled (Fig. 1.I) and can be released from
the strap support (Fig. 7) and carried by hand.
To release the battery backpack, press
on the two upper buttons (Fig. 7.A).
The battery compartments are located
on both sides of the backpack (Fig. 8)
The following can be found on the
right side of the backpack:
• cable socket (Fig. 9.A)
• battery selector (Fig. 9.B)
• one USB port for charging other devices
(e.g. mobile phones) (Fig. 9.C)
To avoid any loose cables, there are
grooves on both sides and at the rear, in
which the power cable can be inserted.
It indicates the
rotation direction of
the cutting means.

5. CONTROLS

5.1 SAFETY BUTTON (ACTIVATION
/ DEACTIVATION)
Press this button to activate
and deactivate the machine's
electrical circuit (Fig. 10.C).
One LED lit: the machine's
electrical circuit is activated. The
machine is ready for use.
Both LEDs lit: the machine
is operative (Fig. 10.D).
LEDs off: The electrical circuit
is completely deactivated.
IMPORTANT Do not keep
your finger on the button when
moving the machine to avoid
accidentally enabling the machine.
The "Warning" icon (Fig. 10.E) comes
ON in the event of machine fault (refer
to the troubleshooting table, par. 14).

5.2 THROTTLE CONTROL LEVER

It allows to start/stop the machine
and simultaneously engages/
disengages the cutting means.
The throttle safety lever (Fig. 10.A) can
only be operated if the throttle safety lever
is pressed at the same time (Fig. 10.B).
For machine start up:
– Simultaneously push the regulator
control lever and safety lever.
Starting the machine causes the cutting
means to start rotating at the same time.
The machine stops automatically as the
throttle control lever is released.
EN - 9