Setting Up And Connecting The Device; Thermostat Control - Beem 06199 Bedienungsanleitung

23

Setting Up and Connecting the Device

PLEASE NOTE!
• Only connect the device to a plug socket that is properly installed and matches the
technical data of the device. The plug socket must also be readily accessible after con-
nection so that the connection to the mains can quickly be isolated.
Do not use the device in conjunction with extension cables.
•
• Do not place the device below kitchen wall units or similar cupboards. The rising steam
could cause damage to them!
• The surfaces of furniture may possibly contain elements which can attack and soften the
feet of the device. If necessary, place a suitable pad below the feet.
1. Place the device on the kitchen unit or another dry, solid, fl at, heat-resistant and splash-proof
work surface. Ensure there is suffi cient clear space on all sides (at least 20 cm to the sides and
30 cm above).
2. Ensure that the thermostat control (7) has been turned anticlockwise until it resists.
3. Fully unwind the connecting cable and connect it to the device connection (10).
4. Connect the connecting cable to a plug socket.
Operation

Thermostat Control

The thermostat control (7) is used to switch the device on and off and set the temperature of the
water.
Switch on
Turn the thermostat control clockwise until it resists.
Switch off
Turn the thermostat control anticlockwise until it resists.
The heating control lamp (9) lights up as soon as the heating element of the device starts heating
the water. The heating control lamp lights up at intervals when the water is boiling at intervals.
Removing / Attaching the Lid
1. Hold the lid (4) at the lid handles (3) and pull it upwards.
If the device has been in operation, use potholders or similar gloves as the lid handles might
be hot. Always allow the device to cool down before using it again.
2. To close the lid, place it on the water reservoir (6).
EN