HBM C10 Montageanleitung Seite 35

Electrical
connection
bridge B
Male connector
selection for the
"fixed cable"
option
C10
The standard version is a bayonet connector
(PT02E10­6P-compatible). The option is also available to
fit a screw-type device plug (PC02E10­6P­compatible).
A third variant where the force transducers are fitted with
a fixed cable is also available. In this version, all C10s
with a nominal (rated) force greater than/equal to 25 kN
achieve protection class IP68.
If you order the C10 with an integrated cable, you can
specify that a male connector assembly be attached to
the end of the cable in order to allow for the direct
connection of the signal conditioner with the force
sensor.
Y = free ends, no male connector assembly
F = D-sub-HD15, 15-pin, for connecting to MGC+
(e.g. AP01)
Q = HD-sub male connector, 15-pin, for connection to
many of the HBM signal conditioners in the series
Quantum (MX410, Mx440, MX840)
N = MS male plug for connecting to HBM signal
conditioners, such as MGC+ (Ap03), DMP
or DK38
P = ODU male connector, 14-pin. Degree of protection
IP68. For connecting to all HBM signal conditioners in the
Somat XR series that are suitable for measuring full
bridge circuits.
M = female connector M12 for connecting HBM
electronics PAD near the sensor
A04036_01_YI0_03 HBM: public
Versions and ordering numbers
33