Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Risk of leakage of batteries / rechargeable
batteries
Avoid extreme environmental conditions and
temperatures, which could affect batteries /
rechargeable batteries, e.g. radiators / direct
sunlight.
Avoid contact with the skin, eyes and mucous
membranes. In the event of contact with battery
acid, thoroughly flush the affected area with
plenty of clean water and seek immediate
medical attention.
WEAR PROTECTIVE GLOVES!
Leaked or damaged batteries / rechargeable
batteries can cause burns on contact with the
skin. Wear suitable protective gloves at all
times if such an event occurs.
In the event of a battery leak, immediately
remove it from the product to prevent damage.
Only use the same type of batteries / recharge-
able batteries. Do not mix used and new
batteries / rechargeable batteries.
Remove the batteries / rechargeable batteries if
the product will not be used for a longer period.
Risk of damage of the product
Only use the specified type of battery /
rechargeable battery!
Insert batteries / rechargeable batteries accord-
ing to polarity marks (+) and (-) on the battery /
rechargeable battery and the product.
Use a dry lint-free cloth or cotton swab to clean
the contacts on the battery / rechargeable battery
and in the battery compartment before inserting!
Remove exhausted batteries / rechargeable
batteries from the product immediately.
Initial use
Remove all packaging materials before first use.
Inserting / replacing batteries
Slide the battery cover
the arrow and remove it.
Safety / Initial use / Installing the LED strip
in the direction of
4
Insert the batteries into the battery compart-
ment
while taking the polarity into account
2
(+ and -).
Only use batteries
"Technical Data".
Slide the battery cover
opposite direction to the arrow.
Hint: Make sure that the battery cover
securely locked in place.
Trimming the LED tape
The LED strip can be trimmed.
DANGER TO LIFE BY
ELECTRIC SHOCK!
Before doing any work on the LED strip
the batteries
from the battery compartment
3
Choose the desired LED strip length.
Note: Ensure that you cut the LED strip at the
right place. The cutting point lies exactly be-
tween the plus and minus pole and is marked
with a black line.
Shorten the LED strip
Be sure to cover the open end of the LED strip
with the adhesive strip
Installing the LED strip
Note: Ensure that the installation area is clean,
grease-free and dry. Otherwise the functionality of
the adhesive strip may be impaired.
Choose a suitable installation area (window etc.).
Remove the protective film
side of the LED strip
Note: When removing the protective film
make sure to start from the side of the supply
cable. Make sure that you do not also peel
away the adhesive coating when removing the
protective film
.
8
Stick the LED strip
onto the installation area and press it on firmly.
Remove the protective film from the adhesive
strip
on the reverse side of the battery com-
5
partment
.
2
specified in the chapter
3
back on in the
4
4
remove
9
using a pair of scissors.
9
before use (see fig. A).
10
from the reverse
8
.
9
with the adhesive strip
9
GB/IE/NI
is
.
2
9
,
8
9
Werbung
Inhaltsverzeichnis
