Speed Of Saw Belt; Adjusting The Speed Of The Saw Belt - S181; Speed Table S181 - Optimum optisaw S 181 Betriebsanleitung

4.6

Speed of saw belt

4.6.1

Adjusting the speed of the saw belt - S181

WARNING!
Do not open the protective cover until you have disconnected the metal band saw from
the power supply.
Close and screw down the protective cover after any adjustment to the saw belt speed.

Disconnect the metal band saw from the power supply.
Protective cover
V-belt
Motor
Fastening screws

Loosen the fastening screws on the motor plate until you can move it to reduce the tension
in the Vbelt.

Place the V-belt in the required position on the pulleys.

Tighten the V-belt by moving the motor back.

Check the tension in the V-belt. The tension in the V-belt is correct if you can push it
approximately 1cm with your finger.

Re-tighten the fastening screws of the motor plate and connect the metal band saw to the
power supply.

Close and screw down the protective cover.
ATTENTION!
Make sure the V-belts have the right tension.
Too heavy or too low tension of the belt can cause damage.
4.6.2

Speed table S181

Operation
Version 1.6.4 - 2020-08-05
Img.4-7: Speed of saw belt
m/min.
Translation of original instruction
S181 | S181G EN
71