IKEA MATALSKARE Bedienungsanleitung Seite 9

ENGLISH
to avoid grease build-up. Remove and
clean or change the filter regularly. To
do this, follow the instructions given in
the paragraph "Cleaning and Mainten-
ance".
• Do not cook food over the flame
("flambé") under the appliance. The use
of open flames may cause a fire.
• Failure to follow the instructions when
cleaning the hood and when cleaning
and replacing the filters may result in the
risk of fire.
• The exhaust air must not be discharged
through the same duct used to extract
the fumes generated by appliances
burning gas or other fuels, but it must
have an independent outlet.
• All national regulations regarding ex-
haust air must be complied with.
• There must be adequate ventilation if
the hood is used with other appliances
burning gas or other fuels. The negative
pressure of the room must not be above
4 Pa (4 x 10-5 bar). For this reason, make
sure that the room is well ventilated. If in
doubt, contact an authorised service
centre or a qualified professional.
Installation
The hood is designed to be installed and
used in "suction" or "recirculation" mode.
Suction version (see the symbol
the installation instructions)
The steam produced while cooking is
sucked in and conveyed outdoors through
an exhaust pipe (not supplied) connected
to the hood steam outlet.
Make sure that the exhaust pipe is
installed correctly in the air outlet using a
suitable connection system.
Important: if already installed, remove the
carbon filter(s).
Air recirculation version
• Do not leave pans on the stove unatten-
ded while frying food, as the oil used for
frying can catch fire.
• Before touching the light bulbs, make
sure that they are cold.
• Do not use or leave the hood without the
light bulb correctly installed, because it
might cause an electric shock.
• The hood is not a worktop: do not place
objects on it or overload it.
• For all installation and maintenance op-
erations, always use suitable work
gloves.
• The appliance is not suitable for outdoor
use.
WARNING: when the hob is on, the
accessible parts of the hood may become
hot.
WARNING: this appliance is heavy; the
hood must be lifted and installed by two or
more people only. The minimum distance
between the hob and the lower part of the
hood must not be less than 65 cm for hobs
with gas or other fuel burners and 50 cm
for electric cookers. Before installing, also
check the minimum distances indicated in
the hob manual. If the hob installation
instructions indicate a greater distance, it
must be taken into account.
(see the symbol
instructions)
The air is filtered through one or more
in
filters and then conveyed back into the
room.
Important: make sure that there is correct
air circulation around the hood.
Important: if the hood is not supplied with
carbon filters, they must be ordered and
installed before using the appliance. The
filters are available at IKEA stores.
The hood must be installed away from
particularly dirty areas, windows, doors
and heat sources.
in the installation
9