Installation; Installation Conditions; Compressor Assembly - EKOM DK50 2V/M Benutzerhandbuch

INSTALLATION

INSTALLATION
Risk of incorrect installation.
Only a qualified professional can install the compressor and place it into
operation for the first time. His obligation is to train the operating personnel on
the use and maintenance of the device. He shall confirm installation and training
of operators by an entry into the installation record (see Annex).

10. INSTALLATION CONDITIONS


The compressor may only be installed and operated in dry, well-ventilated and dust-free
rooms with conditions stated in Technical data
Risk of damage to the device.
Do not operate the device in outdoor environment or in humid or wet rooms.
Explosion risk.
Do not install the device in any rooms, in which explosive gases, dusts or
flammable liquids may be present.

The compressor must be installed in such a way, that it is accessible at all times for operation
and maintenance and label on the device is accessible.

The compressor must stand on a flat, sufficiently stable base (be aware of the compressor
weight, see Technical data).
You may notice a "new product" odour when you first place the product into
service (for a short period of time). This odour is temporary and does not impede
the normal use of the product. Ensure the space is properly ventilated after
installation.

11. COMPRESSOR ASSEMBLY

11.1. Manipulation and fixation removal

Unpack the compressor from the packaging.

For compressors with a cabinet, open the front door and remove the connecting strip (17) in
the front lower part. Remove the cabinet from the compressor.

Put the compressor at the place of operation (Fig. 4).
Use handling straps and the handle on the compressor to move the compressor
as needed. Do not use other parts of the compressor (the air pump, cooler, etc.)
for gripping.
The number of persons required to handle the equipment must be matched to the
weight of the device.
10/2022 25 NP-DK50 2V-3_10-2022-AD