Grinding Stone; Switching On And Off/Setting Speed Range; Notes On Material Processing/Tool/Speed Range; Cleaning, Care And Storage - Parkside PGS 500 A1 Originalbetriebsanleitung

Grinding stone

♦ Grinding work can be performed on various
metals using the grinding stone
Switching on and off/setting speed
range
CAUTION!
■ The rotating direction of the grinding spindle
can be read off the arrow engraved on the
front of the appliance (anticlockwise symbol) .
Switching on/setting the speed range
♦ Set the ON/OFF switch
♦ Set the steplessly adjustable speed control
a position between "1" and "6" .
Switching off
♦ Move the ON/OFF switch
"O" .
Notes on material processing/tool/
speed range
■ The work result depends on the speed, the type
of material and the contact pressure . Carry out
tests on test pieces to determine the optimum
settings .
Position of the
speed control
1
2
3
4
5
6
PGS 500 A1
.
to the "I" position .
to
to the position
Idle speed (rpm)
approx . 4500
approx . 9000
approx . 17500
approx . 22500
approx . 27000
approx . 30000

Cleaning, care and storage

WARNING! RISK OF INJURY!
■ Switch off the appliance and pull out the
power plug before starting any work on
the appliance.
The appliance is maintenance-free .
■ Remove all dirt from the appliance . Use a dry
cloth to do this .
WARNING!
■ If the power cord requires replacement, this
should be carried out by the manufacturer or
an approved representative to avoid safety
hazards .
■ Store the appliance and all the individual
pieces carefully in the provided plastic case to
ensure you do not lose any part .
NOTE
► Replacement parts not listed (such as carbon
brushes, switches) can be ordered via our
service hotline .
WARNING!
■ Always ensure that the power plug or the
mains cable is replaced only by the manu-
facturer of the appliance or its customer
service. This will ensure that the safety of the
appliance is maintained .
GB │ IE │ 9 ■