Grinding With The Dry Grinding Disc; Grinding With The Wet Grinding Disc; Change Grinding Disc; Change Dry Grinding Disc - Parkside PNTS 250 B1 Originalbetriebsanleitung

G B I E
N I
Grinding with the dry
grinding disc
• Place the workpiece on the workpiece
support ( 6) and slowly bring it to its
desired angle on the dry grinding disc
( 5).
to side in order to achieve an optimal
.
ing disc is worn uniformly. Occasion-
ally, allow the workpiece to cool down.
• Fold the spark protection device (
downwards while grinding in order to
avoid injury from sparks.
Grinding with the wet
grinding disc
• Check the water level in the water tank:
submerged in water up to the water level
mark on the water tank (
• Stand in front of the wet grinding disc
( 1).
• Hold the workpiece with both hands
and lower it slowly onto the wet grind-
ing disc.
on the teeth of the water tank (

Change grinding disc

Information on replacement:
• Never operate the device without
protective equipment.
• Ensure that the rotation speed
stated on the grinding disc is the
same or higher than the nominal
rotation speed of the device.
• Ensure that the grinding disc
dimensions match those of the
device.
1 4
All manuals and user guides at all-guides.com
2)
1) is to be
13).
13).
(sound test: an undamaged grind-
ing disc hanging freely on a string
will result in a clear sound if it is
tapped with a plastic hammer).
• Never re-drill a locating hole which
is too small to make it larger.
• Never use separate bushings or
adapters in order to make grind-
ing discs whose hole is too large
• Do not use any saw blades.
.
must be made of elastic materials
e.g., rubber, soft cardboard etc.
• Always reassemble the device
completely after replacing the
grinding disc.
Switch the device off and remove
the mains plug.
Allow the device to cool down.
Wear protective gloves when
changing the grinding discs in or-
der to avoid cutting damages.

Change dry grinding disc:

1. Remove the spark protection (
.
move the dry grinding disc cover
( 4) from the protective hood
(25).
3. Unscrew the grinding disc
nut (22) with a screw wrench
the grinding disc with one hand
wearing a glove.
.
.