Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5
Maintenance
ATTENTION!
Properly performed regular maintenance is an essential prerequisite for
operational safety,
failure-free operation,
long service life of the metal band saw and
the quality of the products which you manufacture.
Installations and equipment from other manufacturers must also be in good order and condition.
5.1
Safety
WARNING!
The consequences of incorrect maintenance and repair work may include:
very serious injury to personnel working on the metal band saw,
damage to the metal band saw.
Only qualified staff should carry out maintenance and repair work on the metal band
saw.
Electrical systems and operating materials may only be installed, modified and repaired
by a trained electrician or supervised and under the control of a trained electrician and
must comply with electrotechnical regulations.
WARNING!
Do not climb onto or into the machine while working.
5.1.1
Preparation
WARNING!
Only work on the metal band saw when the mains plug is disconnected.
Attach a warning sign.
5.1.2
Restarting
Before restarting, run a safety check.
WARNING!
Before starting the machine, you must check that there is no danger for persons and that
the machine is not damaged.
5.1.3
Cleaning
CAUTION!
Use a chip hook for removal of chips and wear suitable protective gloves.
5.2
Checkup, inspection and maintenance
The type and level of wear depends to a large extent on the individual usage and operating
conditions. Any indicated intervals therefore are only valid for the corresponding approved
conditions.
EN
S275N | S275NV
88
Safety check on page 63
Translation of original instruction
Maintenance
Version 1.2.3 - 2021-11-02
Werbung
Inhaltsverzeichnis
