Inhaltsverzeichnis
Werbung
3.2. Remote control commands
122
The cycle number is set to 0 on switching on the instrument and it
is always incremented as long as the instrument remains
switched on.
.V:
Volume
.Meas:
Measured value associated to the cycle number.
The unit "assembly" must be preset (see 3.2.2.94).
3.2.2.96. Setup.SendMeas.Titrator.CyclNo
Setup.SendMeas.Titrator.V
Setup.SendMeas.Titrator.Meas
Setup.SendMeas.Titrator.dVdt
Setup.SendMeas.Titrator.dMeasdt
Setup.SendMeas.Titrator.dMeasdV
Setup.SendMeas.Titrator.ERC
Selection of the values from the titrator which are sent in the set time interval
(see 3.2.2.93, formats see 3.2.2.79):
.CyclNo:
Cycle number. Together with the cycle time (3.2.2.82), a time
frame can be set up. The other data belong to the corresponding
cycle number. The cycle number is set to 0 at the start of a
method and it is incremented until the end of the method.
.V:
Volume.
.Meas:
Measuring value
.dVdt:
associated volume drift.
.dMeasdt: associated measured value drift.
.dMeasdV: associated 1st derivative of the titration curve.
.ERC:
ERC in DET.
The unit "titrator" must be preset (see 3.2.2.94).
3.2.2.97. Setup.AutoInfo.Status
Setup.AutoInfo.P
Setup.AutoInfo.T.R
Setup.AutoInfo.T.G
Setup.AutoInfo.T.GC
Setup.AutoInfo.T.S
Setup.AutoInfo.T.B
Setup.AutoInfo.T.F
Setup.AutoInfo.T.E
Setup.AutoInfo.T.H
Setup.AutoInfo.T.C
Setup.AutoInfo.T.O
Setup.AutoInfo.T.N
Setup.AutoInfo.T.Re
Setup.AutoInfo.T.Si
Setup.AutoInfo.T.M
Setup.AutoInfo.T.EP
Setup.AutoInfo.T.RC
Setup.AutoInfo.I
Setup.AutoInfo.O
ON means that the Titrino reports automatically the moment the correspond-
ing change occurs.
.Status:
Global switch for all set AutoInfo.
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
794 Basic Titrino
Werbung
Inhaltsverzeichnis
