MTR+ Biolito Bedienungsanleitung Seite 37

2. By pressing the program button „P" you can choose from the programs
01 – 05 (pre-programmed).
3. This is followed by pressing the buttons „+/-" below the channel used. The selected
program runs automatically and the LCD displays the intensity as milliamps (mA).
Program
Mode
Intensity
Channel A
In the upper row you can see the remaining program time and in the bottom line the intensity
being applied to each channel. If the button „+" is pressed repeatedly the intensity of stimula-
tion increases. If the button „-" is pressed repeatedly the intensity of stimulation is reduced. For
the setting of the intensity it is vital that one feels the electric current but that discomfort never
occurs.
4. If you wish to interrupt the program, press the button „S" once and the program will pause.
The program will resume for the remaining program time when pressing this button once
again. In this case, the intensity increases within one second to the previous used value.
5. By pressing the „P"-button you pause as well, you can continue with new intensity
adjustment by pressing the +button. If you press „P" a second time the program is finished.
6. Biolito is switched off when pressing the button „On/Off" or automatically one minute after
the program is finished.
Biolito Bedienungsanleitung / Operators Manual
37
Remaining
Program Time
Intensity
Channel B