Cleaning And Maintenance; Cleaning The Appliance; Cleaning And Changing The Purifying Filters - Siemens PA0430M Gebrauchsanweisung

Cleaning the appliance

J For safety reasons, you should unplug the
appliance from the mains electricity supply
before cleaning.
J The appliance can be cleaned with a cloth
or sponge, slightly warm water and a mild
detergent.
J Never use hot water (more than 40ºC),
bleach, benzene, petrol, acid, scouring
pads, brushes or strong detergents. Prevent
water from entering the appliance.
J Do not clean the appliance with a hose.
Cleaning and changing the purifying
filters
To change the purifying filter, it is first
necessary to open the front flap on the
appliance (it is not necessary to remove it).
Pull the flap gently to do this. The flap can be
opened up to the safety stop without risk of
falling, Fig. 28.
Fig. 28
All models are fitted with a basic filter which
needs to be cleaned regularly, Fig. 29. The filter
is accessed by pressing the tab at the top and
removing it from its housing, Fig. 30. The filter is
cleaned under a cold tap, dried and replaced.
Washable
basic filter

Cleaning and Maintenance

Fig. 29
31
Apurifying filter is also fitted inside the basic filter
on these models.
Purifyng
filter
This purifying filter needs to be changed every
year in order to remain operational.
(These accessories are available for purchase
from the Manufacturer's Official Technical
Service and authorised distributors). See
"Description of accessories".
Installing the purifying filter:
J Remove the basic filter from the appliance,
Fig. 30.
J Fit the purifying filter inside the basic filter
as shown in Fig. 31.
J Install the assembly onto the appliance by
lining the lower studs up with the slots on
the front casing of the appliance and
pressing the top clip in until it clicks into
position. The assembly is fitted properly
when it clicks into position.
J Close the front flap.
J In order to maintain cooling power, only fit
one set of filters onto the support.
Fig. 30
Fig. 31