Status And Error Messages - HEIDENHAIN EIB 8000 Betriebsanleitung

5 Operation
5.1 Switch-on / Switch-off
WARNING
Danger of electric shock!
Damaged cables or connections may result in serious
personal injuries or death by electric shock.
Do not operate the device if the power cable or any
connections are damaged
Switch-on
Set the power switch to the
on the location of the power switch, see "Rear panel",
Page 29
After the product has been switched on, it boots the most
recently stored firmware. This is the firmware version
that was loaded during the most recent update. Since
the network parameters can be changed, the settings
programmed most recently are used after switch-on.
In the event of an error (e.g. an update was incorrect),
the product will boot in the factory default setting with
the user network parameters. This boot process takes
significantly longer.
You press the reset button in order to start specialized
loading of the firmware. For more information, see "Reset
modes supported by the product", Page 33.
Switch-off
Set the power switch to the
disconnect the power cable
5.2 Driver software
The driver software enables customers to easily program
their own applications. In addition, example programs
demonstrate possible applications of the products.
The installation and operation of the driver software
are described in the User's Manual for Application
Development, see "Notes on reading the documentation",
Page 22.
32
I position. For information
0 position. Then
5.3

Status and error messages

The product features three LEDs for status display and
eight LEDs for the status display of the slots.
The LEDs display the operating and error states of the
product, as well as the status of the slots.
For information about the location of the LEDs, see "Front
panel", Page 28.
LED Color Status
POWER Green On
Off
LAN Green On
Blinking
Off
STATUS Green On
Blinking
Off
1)
IDP means the functional unit for position value
formation inside the product.
While reset is active, the status LED has a
different meaning, see "Blinking pattern of the
STATUS LED during a reset", Page 33
Meaning
Power supply ready
Power supply missing
Ethernet connection
established
Product is currently
booting or in "Identify
Mode"
Ethernet connection
separated
System ready
Software or firmware
is being updated,
or reset mode is
signaled
System is being
booted
HEIDENHAIN | EIB 8000 | 09/2018