BURG WÄCHTER secuENTRY Set ENTRY Home 5001 PIN Hauptanleitung Seite 32

secuENTRY 5000 CYL installation
The installation of the secuENTRY
5000 CYL is explained below. Prior to
installation, please read the installation
instructions carefully.
Remove the existing door lock cylinder
1
by loosening the forend screw in the
door and pulling out the cylinder with
the key inserted (Fig. 98).
Remove the two hexagonal screws
2
in the two knobs with the enclosed
hexagonal spanner (Fig. 99).
Pull o the knob on the outside
3
completely and pull the knob on the
inside as far back as possible (Fig. 100).
!
Tip: The knob on the inside is larger
than the knob on the outside.
!
Attention: The knob on the inside
cannot be pulled o . Do not try to
loosen it by force.
14 I Englsih
1.
4x
2 mm
!
OUTDOOR INDOOR
4 From inside the door, push the cylinder
into the mortise lock (Fig. 101).
2.
5 Screw the cylinder into the door and
push the inside and outside knobs up
to the door (Fig. 102).
Fig. 98
Fig. 99
Screw the hexagonal screws back into
6
the two knobs (Fig. 103).
!
ATTENTION: Ensure that the knob is
at least one millimetre away from the
door.
Fig. 100
If you have not already done so, remove
7
the battery protection strip from the
battery compartment on the inside
knob (Fig. 104).
min. 1 mm min. 1 mm
2 mm
secuENTRY HOME 5000 CYL
Fig. 101
Fig. 102
Fig. 103
Fig. 104