Start/Stop The System; Resetting Of Fault Indications; Radio Communication Or Infrared Communication - Biral ComBo easy Serie Montage- Und Betriebsanleitung

86 english
|
7.3

Start/stop the system

Start each pump by pressing
indicated.
Stop the system by pressing
to the button will illuminate.
Each pump can also be stopped by continuously pressing
If a pump has been stopped by pressing
by pressing again.
If a pump has been stopped by pressing
The pump can also be stopped with the Grundfos Go Remote or via a digital input set to
"External stop".
No information on the control panel when the system is switched off using but-
ton
7.4

Resetting of fault indications

A fault indication can be reset in one of the following ways:
– Via the digital input if it has been set to "Alarm resetting".
– Briefly press
– A fault indication cannot be reset by pressing
– Switch off the power supply until the indicator lights are off.
– Switch the external start/stop input off and then on again.
7.5

Radio communication or Infrared communication

Radio communication can take place at distances up to 30 metres. It is necessary to enable
communication by pressing
or by continuously pressing
on each pump. When the pump is stopped, the "Stop" text next
. LED lights up green.
or on one of the pumps. This will not change the setpoint.
on the pump control panel.
Änd.Index Datum Visum
Ersetzt durch: Ersatz für:
II I
Massstab
Saver, ComBo gezeichnet 11.04.2017 ts
4:1
Bedientaste STOP, FUNK, WLAN geprüft
Freigabe
BA
PDM_Nr TD-0036193
Zeichnungsnummer Änd.Index
Biral AG
96202705 00
CH-3110 Münsingen
until none of the light fields are on.
, it can only be given free to operation
it can only be restarted by pressing
or if the buttons have been locked.
until the desired setpoint is
.