Service Information; Transport; Disposal And Recycling - Scheppach HC20Si Twin Original Bedienungsanleitung

Check the pressure vessel for signs of rust and dam-
age each time before using. Do not use the compres-
sor with a damaged or rusty pressure vessel. If you
discover any damage, then please contact the custom-
er service workshop.
m Important!
The condensed water from the pressure vessel will
contain residual oil. Dispose of the condensed water
in an environmentally compatible manner at a suitable
collection point.
10.3 Safety valve (Fig. 2)
The safety valve (9) has been set for the highest per-
mitted pressure of the pressure vessel. It is not permit-
ted to adjust the safety valve or remove the connection
lock between the exhaust nut and its cap.
Actuate the safety valve every 30 operating hours but
at least 3 times a year, to ensure that it works when
required.
Turn the perforated drain nut anti-clockwise to open it.
Now, the valve audibly releases air. Then, tighten the
exhaust nut clockwise again.
10.4 Cleaning the intake filter (Fig. 4)
The intake filter prevents dust and dirt being drawn in.
It is essential to clean this filter after at least every 300
hours in service. A clogged intake filter will decrease
the compressor's performance dramatically. Open the
screw (18) to remove the intake filter.
Then pull off the filter cover (17). Now you can remove
the air filter (16). Carefully tap out the air filter, filter cover
and filter housing. Then blow out these parts with com-
pressed air (approx. 3 bar) and reinstall in reverse order.
10.5 Storage
m Important!
Pull out the mains plug and ventilate the equip-
ment and all connected pneumatic tools. Switch
off the compressor and make sure that it is se-
cured in such a way that it cannot be started up
again by any unauthorized person.
m Important!
Store the compressor only in a dry location which
is not accessible to unauthorized persons. Always
store upright, never tilted!
10.5.1 Releasing excess pressure
Release the excess pressure by switching off the com-
pressor and using the compressed air which is still left
in the pressure vessel, e.g. with a compressed air tool
running in idle mode or with a blow-out pistol.

10.6 Service information

Please note that the following parts of this product are
subject to normal or natural wear and that the following
parts are therefore also required for use as consuma-
bles. Wear parts*: belt, coupling
* Not necessarily included in the scope of delivery!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.

11. Transport

Use the transport handle (1) to transport the device,
and drive the compressor with it.
The handle height can be adjusted on the height ad-
justment (5), as shown in figure 5. The handle height
can be adjusted from 53 cm up to 82.5 cm.
When lifting the compressor, note its weight (see
Technical data). Ensure that the load is well secured
when transporting the compressor in a motor vehicle.

12. Disposal and recycling

Notes for packaging
Notes on the electrical and electronic equipment
act [ElektroG]
Waste electrical and electronic equipment
does not belong in household waste, but
must be collected and disposed of sepa-
rately!
• Old batteries or rechargeable batteries that are
not permanently installed in the old unit must be
removed before handing them in! Their disposal is
regulated by the battery act.
• Owners or users of electrical and electronic devices
are legally obliged to return them after use.
www.scheppach.com
The packaging materials are recy-
clable. Please dispose of packag-
ing in an environmentally friendly
manner.
GB | 25