FX180eco
16-05-2002
Description of the remote control
REMOTE CONTROL
Inserting the batteries
• Slide the cover as shown in figure.
• Insert two new non-rechargeable batte-
ries, being careful to place them in the
correct positions (+) and (-).
• Put the cover back on, letting it slide into its
original position.
• The Display will show all of the remote con-
trol's symbols for several seconds.
At this point the clock on the display will start
to blink showing 12:00 o'clock; at this point
set the correct time.
Note: WE SUGGEST USING ALKALINE BATTE-
RIES.
If the remote control is to be replaced or
thrown away, the batteries must be remo-
ved and disposed of in accordance with
the current laws as it represents an environ-
mental hazard.
SETTING THE CLOCK
• If the time is not set within two minutes of
the reset or of battery replacement, the
remote control will automatically read
12:00.
• To programme the hour, push the
keys to move ahead or back. The seg-
ments are of one minute.
If you hold the buttons down, the minute
designations will run more quickly.
• The clock will continue to blink. Push the
SET button to confirm the time set: the
clock will then stop blinking.
• If you have to adjust the time, you must
push the RESET button and then enter the
correct time. (There is no other way to do
this).
PROPER USE
• Point the remote control toward the air-
conditioner's signal receiver
• Maximum distance: about seven (7)
metres (without any obstacle between
remote control and receiver).
• The remote control must be handled with
great care: do not drop it, expose it to
direct sunlight, or leave it close to heat
sources.
26
14:53
Pagina 26
10
.
MODE
MODE