Shark AI360ROBOT Gebrauchsanweisung Seite 29

1m
1m
1.6m
• Select a permanent location for the Base because every time you relocate the base, your robot will have
to completely re-map your house. Remove protective film from robot and base.
• Place the base with its back against a wall. Select a level surface on a bare floor in a central area with a
strong Wi-Fi signal. Do not place base against baseboard heaters or other heating elements.
• Remove any objects that are closer than 1 meter from either side of the base or closer than 1.6 meters
from the front of the base.
• Plug in the base. Make sure the power switch on the back of the base is in the (I) ON position. The Base
Power Indicator Symbol ( ) on the top right side of the base will illuminate when the base has power.
INSTALLING THE SIDE BRUSHES
sha rkcl e a n.eu
BASE SETUP
The Base Power
Indicator Icon
INDICATOR
Snap the 2 included Side Brushes onto the square
pegs on the bottom of the robot.
ROBOT BATTERY INDICATOR LIGHTS
NOTE: If the low charge light is blinking red, there is not enough battery power for the robot to return to the base.
Manually place the robot on the base.
TIP: To preserve battery life, if the robot will not be used for a long time, turn off the power on the robot by pressing the
CLEAN button and holding it for 5-7 seconds. The robot should be recharged at least once every three months.
To turn robot off, take robot off base and press the CLEAN button on the robot for 5-7 seconds.
BASE INDICATOR LIGHTS
sh a rkcl ea n.eu
In Use
Full Partial Low
Charge Charge Charge
(White) (White) (Red)
While
Charging
(White)
No Charge
or Off
The white charge indicator lights show how much
battery power is remaining.
While the robot is charging, both white LED lights
will flash. When charging is complete, both will
illuminate steadily. It may take up to 6 hours to fully
charge your robot.
If the robot is idle and away from the charging
base for 10 minutes, it will enter Sleep Mode. The
indicator lights will turn off, but the battery and
Wi-Fi lights will remain on in sleep mode. Wake up
the robot by pressing any button.
Base Power
Indicator Icon
Base is plugged in
and has power.
Charging
Icon
Robot is properly aligned
on base and charging.
Evacuation
Icon
Robot is emptying
debris into base.