Intended Use - Makita AN454 Betriebsanleitung

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Air pressure
Fastener
Nail capacity
Pneumatic tool oil
Minimum hose diameter
Dimensions (L x W x H)
Net weight
•
Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
•
Specifications may differ from country to country.
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
Read instruction manual.
Wear safety glasses.
Wear ear protection.
The tool has the capability of operating in
contact actuation mode.
Do not use on scaffoldings, ladders.
Type
Length
Diameter
0.49 - 0.83 MPa (4.9 - 8.3 bar)
Wire coil nails (roofing nails)
ISO VG32 or equivalent
256 mm x 117 mm x 271 mm

Intended use

The tool is intended for the preliminary interior work
such as fixing floor joists or common rafters and framing
work in 2" x 4" housing.
The tool is for high-volume professional application only.
Do not use it for any other purpose. It is not designed to
drive fasteners directly on a hard surface like steel and
concrete.
Noise
The typical A-weighted noise level determined
according to ISO11148-13(EN12549): Sound pressure
level (L ) : 102 dB(A)
pA
Sound power level (L
WA
Uncertainty (K) : 1.5 dB(A)
NOTE: The declared noise emission value(s) has
been measured in accordance with a standard test
method and may be used for comparing one tool with
another.
NOTE: The declared noise emission value(s) may
also be used in a preliminary assessment of
exposure.
6 ENGLISH
AN454
19 mm - 45 mm
3.05 mm
120 pcs.
6.5 mm
2.4 kg
) : 113 dB (A)