7
Turn the chain tensioner counter-clockwise to tension
the chain. Make sure that you can lift the chain up 1-2
mm from the middle of the bar.
8
Use your hand to let the saw chain move. Make sure
that it moves smoothly in the slot in the bar.
9
Install the chain guard and tighten the locking knob
for the chain guard. (Figure 6)
Note! If the chain is new, do a check of the tension after a
few minutes of use. If necessary, adjust the tension.
3.2 To fill with saw chain oil
Caution! Do not use a product with no chain oil.
Regularly do a check of the oil level.
Caution! Make sure that no dirt gets into the oil tank.
1
Release the oil tank cap (A).
2
Carefully fill with chain oil to the top mark on the
sight glass (B). Refer to "3.2.1 Saw chain oil" on page
47 . (Figure 7)
3
Wipe up spilled oil.
4
Install the oil tank cap.
3.2.1 Saw chain oil
Caution! Do not use used oil or oil that is not recom-
mended by the manufacturer.
● Use eco-friendly chain oil of good quality.
● Only use oil intended for saw chains.
● Only use oil that is recommended by the manufacturer.
3.2.2 To do a check of the chain lubrication
1
Start the product, refer to "4.2 To start the product" on
page 47.
2
Hold the bar 15 cm above the surface for 15 s.
If the chain lubrication operates correct, oil drops on the
surface.
47
3.3 To install the battery
Note! Charge the battery as described in the instructions for
the battery charger.
● Press the charged battery into the battery holder. Make
sure that the battery holder locks. (Figure 8)
3.4 To remove the battery
● Press the lock button (A) and remove the battery (B).
(Figure 9)
4
Operation
4.1 To use the product
Warning! Even if the product is used in accordance
with the instructions it is impossible to rule out all risk
factors.
Warning! Always do a check of the kickback guard/
chain brake before use. Do not use the product if the kick-
back guard/chain brake does not operate correct.
● Examine the product. Make sure that all screws are tight,
that all safety devices are correctly installed and that
moving parts do not jam.
● Do a check of the chain tension. Refer to "3.1 To assemble
the bar and the chain" on page 46.
● Do a check of the kickback guard/chain brake. Refer to
"2.12.4 To do a check of the chain brake" on page 45.
● Do a check of the chain lubrication. Refer to "3.2.2 To do a
check of the chain lubrication" on page 47.
● Do a check for oil leakage.
4.2 To start the product
1
Make sure that the chain does not touch the ground
or an object.
2
Press the lock for On/Off button (A).
3
Press the On/Off button (B). (Figure 10)
4.3 To do a check of the battery status
● Press the button on the battery to lit the battery status
lights. (Figure 11)
2022_001