Temperature Indication; Temperature And Humidity - TFA TWIN PLUS 30.3049 Bedienungsanleitung

TFA_No_30.3049_Anleitung_08_22
Wireless Thermo-Hygrometer
C: Housing:
C 1: Wall mount hole
C 2: Battery compartment
C 3: Stand (fold out)
5.2 Outdoor transmitter (Fig. 2):
D 1: Transmission signal lamp
D 2: Display of temperature and humidity
Buttons inside the battery compartment
D 3: RESET button
D 4: °C/°F button
Housing:
D 5: Wall mount hole
D 6: Battery compartment
D 7: Stand (fold out)
6. Getting started
Insert batteries:
• Place both instruments on a desk with a distance of approximately 1.5
meter. Check that no other electronic devices are close.
• Open the battery compartment of the transmitter by pulling the battery
compartment cover downwards (see marking) and lift up the cover.
• Insert two new batteries 1,5 V AAA, ensure battery polarities are correct.
• Close the battery compartment again.
• Open the battery compartment of the base station and insert two new bat-
teries 1,5 V AAA, ensure battery polarities are correct.
• A brief beep tone will sound and all LCD segments will light up for a short
moment.
• Close the battery compartment again.
• The indoor temperature and humidity appear in the display.
Reception of the outdoor values
• After the batteries are inserted the outdoor temperature and humidity will
automatically be transmitted to the base station.
• The reception signal-symbol flashes. The base station will scan for 3 minu-
tes the outdoor values.
• To toggle to the display of the outdoor temperature and humidity press
the SEARCH/IN/OUT button in normal mode.
16
23.08.2022 12:03 Uhr Seite 9
Wireless Thermo-Hygrometer
• If the reception of outdoor temperature and humidity fails, "- -.-" appears
on the display. Check the batteries and try it again. Check if there is any
source of interference.
• Manual initialization can be helpful. Press and hold SEARCH/ IN/OUT but-
ton of the base station for 3 seconds in outdoor mode.
• A brief beep tone will sound, "- -.-" and the reception symbol flash on the
display. The base station will scan the outdoor values.
7. Operation
• The instrument will automatically quit the setting mode if no button is
pressed within 15 seconds.
• Every press of a button is confirmed with a short beep.
7.1 Store and reset of the maximum and minimum values
• As soon as the base station and the outdoor transmitter are active the
maximum and minimum values for indoor and outdoor will be stored and
reset automatically after 24 hours.
• Press and hold SEARCH/IN/OUT button for 3 seconds in the outdoor
mode to clear the maximum and minimum outdoor values manually. At
the same time the reception for the outdoor transmitter will be activated.
• Press the RESET button with a pointed pin or remove the batteries to
clear all recorded values.

7.2 Temperature indication

• Press the ▼/°C/°F button at the backside of the base station in normal
mode to change between °C (Celsius) or °F (Fahrenheit) as temperature
unit.

7.3 Temperature and humidity

• The display shows the current indoor temperature and the humidity,
the comfort level and the maximum and minimum values for the past 24
hours.
• Press the SEARCH/IN/OUT button.
• The display shows the current outdoor temperature and the humid-
ity, the comfort level and the maximum and minimum values for the past
24 hours.
• Press the SEARCH/IN/OUT button again.
• and the circle symbol appear on the display.
• All outdoor and indoor values will appear alternating for 6 seconds.
• Press the SEARCH/IN/OUT button again to return to normal mode.
17