General Device Functionality; Switching On The Device; Switching Off The Device - TechniSat DIGITRADIO 4 C Bedienungsanleitung

If you want to set the maximum volume, shortly before reaching the
maximum possible volume, a message appears [Attention! High volume!
OK?]. Confirm the setting by pressing the OK button. You can then adjust the
volume to the maximum possible value. The setting is saved until you turn
the device off/on again.

5.4 General device functionality

5.4.1 Switching on the device

> In order to guarantee good DAB+/FM reception, please fully extend the antenna
located on the back of the device. To do so, please refer to Section 5.3.1.
> First prepare the DIGITRADIO 4 C for operation as described in Sections 5.3.1
and 5.3.2.
> Press the VOL/STANDBY knob (5) or On/Standby button (26) on the remote
control to turn on the DIGITRADIO 4 C.
After switching on the device for the first time, you must first set the
[Language]. Using the  or  buttons, select one of the available languages
and confirm by pressing the OK button. The device then automatically
performs a complete scan in DAB mode. While scanning, the display
information shows the progress as well as the number of digital radio stations
detected. After completing the station scan the first DAB+ channel is played.

5.4.2 Switching off the device

> By briefly pressing the On/Standby button you can switch the device to
standby mode. [Standby] appears briefly on the display. The date and time
are shown on the display. The display brightness in standby mode can be
adjusted by following the instructions in Section 12.2.
> Pressing and holding the On/Standby button will put the device in power-
saving mode and the display will go off. [Power off] appears briefly on the
display.
54