Dmx Operation - EuroLite LED Twin Scan Bar Bedienungsanleitung

DMX operation

Setting the number of DMX channels and the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with 14 control channels.
However, it can also be switched to a mode with 2, 5, 7 or 8 channels if different functions are required. To
be able to operate the device with a DMX controller, the DMX starting address must be set. The starting
address depends upon which DMX controller is being used. Please refer to the controller's documentation.
1 Call operating mode DMX in the menu and confirm with ENTER.
2 Use the UP and DOWN buttons to select the desired DMX channel mode: 2CH (2 DMX channels), 5CH
(5 DMX channels), 7CH (7 DMX channels), 8CH (8 DMX channels), or 14CH (14 DMX channels).
Confirm with ENTER.
3 Navigate to menu item dXXX using the UP and DOWN buttons and confirm with ENTER. Use the UP
and DOWN buttons to set the starting address. Confirm with ENTER.
4 The starting address in the menu is green when DMX signals are being received. If no control signals
are available, the starting address set is red.
5 You can adjust the behavior in case of missing DMX signal in the system settings under the menu item
Setup > FAIL: ON = Most recent DMX value is held or OFF = LEDs are switched off (default setting).
Note: Please make sure you do not have any overlapping channels in order to control each device correctly
and independently from any other fixture in the DMX chain. If several devices are addressed to the same
address, they work synchronously.
Overview for gobo and color wheel:
7 Gobos and open 7 Gobos and open
open open
Color wheel 7 dichroic filters plus open Color wheel 7 dichroic filters plus open
blue blue
orange orange
red red
36/44
open open
pink pink
yellow yellow
cyan cyan
00141601.DOCX, Version 1.0
green green