Dmx Operation; Functions In Dmx Mode - EuroLite LED FLD-1508 UV Panel Bedienungsanleitung

• If the range of the remote control decreases, replace the battery. For this purpose, on the rear side of the
remote control press the small bar with the groove to the right and at the same time remove the battery
support. For operation, one 3 V button cell type CR 2025 is required. When inserting, pay attention that the
positive pole of the button cell shows upwards in the support.
• Remove the battery from the remote control as a precaution if the device is not used for a longer period of
time.

DMX operation

Setting the number of DMX channels and the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with 4 control channels.
However, it can also be switched to a mode with 1 channel if different functions are required. To be able to
operate the device with a DMX controller, the DMX starting address must be set. The starting address
depends upon which DMX controller is being used. Please refer to the controller's documentation.
1 Press the MENU button so many times until Addr is indicated in the display. Confirm with the ENTER
button.
2 The display indicates 1 CH (1 DMX channel) or 4 CH (4 DMX channels). Use the buttons UP and DOWN
to select the desired number of DMX channels. Confirm with the ENTER button.
3 Now the display indicates the menu item for the DMX start address d***. Use the buttons UP and DOWN
to set the address. Confirm with the ENTER button.
4 The display will not blink when DMX signals are being received. If no control signals are available, the
display will blink.
Note: Please make sure that you do not have any overlapping channels in order to control each device
correctly and independently from any other fixture on the DMX chain. If several devices are addressed
similarly, they will work synchronically.

Functions in DMX mode

1-channel mode
Channel
1
4-channel mode
Channel
1
Master dimmer
2
Strobe
3
Color adjustment
3
Preset color/
Internal programs
Value
000 – 255 UV 0-100%
Value
000 – 255 Total brightness 0-100 %
000 – 009 No function
010 – 255 Strobe, slow > fast
000 – 255 UV 0-100%
000 – 009 No function
010 – 019 UV
020 – 059
Auto program 1: slow > fast
060 – 099
Auto program 2: slow > fast
100 – 139 Auto program 3: slow > fast
140 – 179
Sound program 1: slow > fast
180 – 219
Sound program 2: slow > fast
220 – 255 Sound program 3: slow > fast
24/28
Function
Function
00120790.DOCX, Version 1.0