Machine Information - Ferm MSM1033 Originalbetriebsanleitung

TABLE SAW / MITRE SAW
The numbers in the following text correspond
with the pictures at page 2 - 4
Before using the machine, thoroughly
read these instructions for use. Make
sure that you know how the machine
works and how to operate it. Maintain the
machine according to the instructions and
make sure that it works properly. Keep
these instructions for use and the other
documentation with the machine.
Contents

1. Machine information

2. Safety
3. Mounting accessories
4. Operating
5. Service and Maintenance
1. Machine information
Introduction
The bench saw – mitre saw is for sawing wood
and woody pieces of work.
Specifications
Voltage
Capacity
Machine class
Revolutions, not under load
Saw blade measurement
Angle for mitring
Angle for bevelling
Table saw maximum
sawing capacity
Mitre saw maximum
sawing capacity:|
- Mitre 0º, Bevel 0º
- Mitre 45º, Bevel 45º
- Mitre 45º, Bevel 0º
- Mitre 0º, Bevel 45º
Weight
Lpa (sound pressure)
Lwa (acoustic capacity
Vibration level
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in EN
61029; it may be used to compare one tool with
another and as a preliminary assessment of
exposure to vibration when using the tool for the
Ferm
applications mentioned
•
•
Protect yourself against the effects of
vibration by maintaining the tool and its
accessories, keeping your hands warm, and
organizing your work patterns.
Contents of the packaging
1
1
1
1
1
1
1
1
1
1
Part names
Figs. 1 to 4
1. On/off switch (cross-cut saw)
2. Operating handgrip
3. Unlocking button
230 V ~ 4. Upper bench surface locking screw
1300 W
5. Dust bag connection
II (double insulated)
6. Rotary knob for bevelling
5000 rpm
7. Scale for bevelling
210 x 30 x 2.6mm
8. Locking knob
45º (left and right)
9. Locking knob for setting the mitre angle
45º (only left)
10. Scale for bevelling angle
30 mm 11. Mounting hole
12. Mitre saw surface
13. Guide stop
120 x 60mm
14. Saw blade protector
90 x 40mm
15. On/off switch (bench saw)
90 x 60mm
16. Lower protective hood
120 x 40mm
17. Guide
11.2 kg
94.2+3 dB(A)
18. Upper bench surface
107.2+3 dB(A)
19. Upper saw blade protector
<2.5 m/s
2
20. Riving knife
21. Flange
22. Saw blade
23. Saw blade bolt
24. Bench inlay
25. Degree arc
26. Clamp screws
27. Flange key
using the tool for different applications, or with
different or poorly maintainted accessories,
may significantly increase the exposure level
the times when the tool is switched off or when
it is running but not actually doing the job, may
signifi cantly reduce the exposure level
Table saw / mitre saw
Dust bag
Parallel guide
Flange key for changing the saw blade
Socket spanner
Allen key
Stick for pushing the work
Instructions for use
Safety instructions
Guarantee card
EN
5