Function Check; Warning Information - Truma Elektroboiler Einbauanweisungen

Electrical connection 230 V
The electrical connection is only to be carried out by
an expert (in accordance with VDE 0100, part 721 or
prIEC 60364-7-721 in Germany). The information given here
is not intended as instructions for you to carry out. It is for
assisting the expert assigned to carry out the job, acting as
auxiliary information when connecting the appliance!
Connection to the mains is effected by means of the cable,
3 x 1.5 mm 2 (e.g. hose line HO5VV-F) to a distribution socket
(fig. A + B: 24 – not included in the scope of supply). A con-
nection cable with a mains plug os not permissible.
Always pay attention to use the correct colour code!
For maintenance or repair work there must be a disconnect-
ing device on the vehicle for all-pole disconnection from the
mains with a minimum contact gap of 3.5 mm.
Figs. A + B
Attach distribution box (24) to floor or wall of vehicle near
device (cable length 110 cm).
Connect the control panel cable, 230 V lead, and heating
element cable as shown in the circuit diagram.
1 = Control panel
2 = Supply line 3 x 1.5 mm
3 = Heater element
4 = brown
5 = green
6 = blue
7 = yellow
8 = white
9 = yellow/green
All cables must be secured with cable clips!
2

Function check

The water connections must be checked for leaks and all func-
tions must be tested as described in the operating instructions
after installation.
Then it must be ensured that all of the water (14 litres) drains
when the system is emptied.
There shall be no claims under guarantee for damage
caused by frost.

Warning information

The yellow sticker with the warning information, which is
enclosed with the appliance, must be affixed by the installer
or vehicle owner to a place in the vehicle where it is clearly
visible to all users (e.g. on the wardrobe door)! Ask Truma to
send you a sticker, if necessary.
The right to effect technical modifications is reserved.
7