Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
•
Take extra care when handling the cutting blades (especially when removing them and cleaning them),
the blades are very sharp and can cause injuries.
•
Before replacing accessories that move during use, switch off the appliance and disconnect it from the
power supply.
•
Tighten the locking ring of the machine carefully before starting. Never overtighten the nut!
•
Never use your fingers, kitchen utensils or other objects to stuff food into the grinder! Use only the tamper
supplied with the accessories. Use reasonable force. Excessive pressure could damage the appliance.
•
Grind meat with tendons and bones removed and cut into pieces about 2.5 cm large.
•
If the grinder gets jammed, switch off the appliance immediately and disconnect it from the mains. Only
then disassemble and clean the grinder.
•
Allow the appliance to cool down before cleaning and storing. Use damp cloth for cleaning and
maintenance. Do not use chemical agents.
Grater
This accessory is designed for slicing and grating fruits, vegetables, nuts, chocolate and hard cheeses. Not
suitable for slicing extremely hard products (such as nutmeg, coffee beans or cereal grains).
•
Take extra care when handling the graters (especially when removing them and cleaning them), the
graters are very sharp and can cause injuries.
•
Never use your fingers, kitchen utensils or other objects to push food into the grater! Use only the tamper
supplied with the accessories. Use reasonable force. Excessive pressure could damage the appliance.
•
If food residues get stuck in the grater, switch off the appliance immediately and disconnect it from the
mains. Only then remove and clean the grater.
•
Before replacing accessories that move during use, switch off the appliance and disconnect it from the
power supply.
•
Use damp cloth for cleaning and maintenance. Do not use chemical agents.
ASSEMBLING THE KITCHEN ROBOT
•
Before first use, clean all accessories with lukewarm water and detergent rinse and dry thoroughly. Do
not immerse the body of the robot in water. Wipe it with a damp cloth. Do not use any abrasive or other
aggressive cleaning agents.
•
Place the robot on a flat, clean and dry table so that it has enough space around it.
•
Turn the multifunction head release lever 2 clockwise (see figure 1) and at the same time lift the
multifunction head (12) with your other hand until you hear a click. The head is now locked in the top
position (see figure 2).
•
Place a stainless steel bowl 4 with ingredients on the base of the appliance 13 and secure it in place by
turning it clockwise (see figure 3).
•
Make sure that the total amount of ingredients does not exceed 1.5 kg.
•
Insert the bowl cover (8) on the multifunction head first and then the required accessories (5, 6, 7) on
the head shaft (1). Push the accessory up and then turn it a quarter turn counterclockwise to the locking
position (Figures 4 and 5).
•
Press the multifunction head release lever (2) while lowering the multifunction head (12) to a horizontal
position. The head must "click" into the base.
•
Insert the plug into the socket and the display will light up.
•
Select the time on the display. Select the speed with the rotary knob. After the set time has elapsed, the
kitchen robot automatically shuts off. Turn the mixer to the "0" position with the rotary knob. For more
information on controls see the chapter "DESCRIPTION OF THE CONTROL PANEL AND DISPLAY".
•
Turn the multifunction head release lever (2) and lift the head (12). Turn the bowl counterclockwise,
remove and remove the finished dough.
Note: When the head is tilted, the control panel display turns off. Lights up again when the head is tilted back.
Note: It is not possible to use two accessories at the same time (e.g. whisk with a grinder, etc.).
WARNING: Do not leave the appliance running continuously for more than 15 minutes. Allow it to cool for at
least 30 minutes before starting again.
8
Werbung
Inhaltsverzeichnis
