Hacker HST-120 Betriebsanleitung Seite 42

For the connection of a BLDC motor via the 3 phases we recommend the use
of 4mm gold contact plugs. These can then be plugged directly into the sockets
provided on the controller side.
For the temperature measurement at the motor we recommend the use
of a PT-1000 sensor, this is already parameterized by the system. Other
sensors are only supported after prior adjustment of the FW.
Settings – Motor
Here you set the parameters to optimally adjust the controller to the hardware of your drive:
Motor settings:
Advance: Enter the advance angle here.
Pole pair: Enter the number of pole pairs here.
Control settings:
Select the type of control here.
Limits:
Enter limits here according to the function in order not to overload the drive.
Brushless DC Controller HST-120
Orginal operating manual
Mounting and commissioning
Page 42 of 45
Rev1.3