Safety Summary; Installation Work; Selection Of Installation Place - Hitachi PC-ARFP1E Installations- Und Betriebshandbuch

SAFETY SUMMARY

1 SAFETY SUMMARY
Hitachi cannot anticipate every possible circumstance that might
involve a potential hazard.
!
D A N G E R
• DO NOT pour water into the remote controller. This product is
equipped with electrical parts. If poured, it will cause a serious
electrical shock.
• DO NOT perform installation work and electrical wiring connec-
tion by yourself. Contact your Hitachi distributor or dealer and
ask them for installation work and electrical wiring by service
person.
!
C A U T I O N
• DO NOT install the indoor unit, outdoor unit, controller and cable at
such places as;
- Where there is oil vapor and the oil is dispersed.
- Where the hot springs are near (in a sulfuric environment).
- Where generation, flowing, staying or leaking of flammable gas is
detected.
- Where the sea is near (in the salty environment).
- An acid or alkaline environment.
• DO NOT install the indoor unit, outdoor unit, controller and cable
within approximately 3 meters from strong electro magnetic wave
radiators such as medical equipment. In case that the controller is
installed in a place where there is electromagnetic wave radiation,
shield the controller and cables by covering with the steel box and
running the cable through the metal conduit tube.
• In case that there is electric noise at the power source for the indoor
unit, provide a noise filter.
• Use specified cables to connect between indoor unit and remote
control switch. Selecting incorrect cables may lead to fire or electrical
shock.

2 INSTALLATION WORK

2.1 SELECTION OF INSTALLATION PLACE

Select a suitable place for handling and determine the
installation place of the controller with the customer's
acceptance.
Do not install the controller at such places as:
- Where children can touch.
Where the air from the air conditioner is directly
-
discharged.
Especially in case that a Remote Controller thermostat is used,
select the installation place in consideration with the following
points:
- Where the average room temperature is detectable.
Where the thermostat is not exposed directly to the sun.
-
Where there is no source of heat.
-
- Where the thermostat is not affected with the outdoor air
by opening and closing doors.
1 PMML0404A rev.1.1 - 06/2022
?
N O T E
• The installer and system specialist shall comply with local regulations
or standards for the safety. The following standards may be applicable,
if local regulations are not available. International Organization for
Standardization, ISO5149 or European Standard, EN378 or Japan
Standard, KHKS0010.
• Perform electrical work according to the Installation Manual. As for
the electrical wiring work and check, turn OFF the main power supply
before opening/closing the service cover of indoor unit. If service
cover is opened with main power supply left on, it may result in an
electrical shock.
• It is assumed that this control remote will be operated and serviced by
English speaking people. If this is not the case, the customer should
add safety such as and operating signs in the native language for non
English speakers.
• This manual should be considered as a permanent part of the air
conditioning equipment and should remain with the air conditioning
equipment.
• This appliance must be used only by adult and capable people,
having received the technical information or instructions to handle
this appliance properly and safely.
• Children should be supervised to ensure that they do not play with
the appliance.
• Important: read and understand this manual before using this remote
controller.
If you have any questions, contact your Hitachi distributor or
dealer.
Prior to the installation work, ensure that foundation is flat,
level and sufficiently strong and then fix the unit securely. If the
foundation is not strong enough, it may lead to injuries caused
by falling of the product, electrical shock or fire.