Proper Levelling - Pkm GSP9-5FI Bedienungsanleitung

WARNING! The power cable and the hoses must not be kinked or
bent when installing the appliance in the installation opening.
3. The free space between the top of the appliance and the worktop must be less
than 5 mm; see also chapter 2.9 P
4. The door of the appliance must be aligned with the adjacent cupboard doors.

2.9 Proper levelling

❖ The appliance must stand in a stable and level position to ensure proper
operation. The supporting feet must stand firmly on the ground so that the
appliance does not wobble. Adjust the supporting feet accordingly. The firm
contact of the supporting feet with the ground also ensures that the appliance
does not vibrate or move unintentionally.
❖ The dishwasher must also be levelled horizontally so that the dish racks operate
properly and the cleaning efficiency is guaranteed.
❖ The maximum permissible inclination angle under the entire appliance is 2°.
Adjust the appliance with its supporting feet horizontally. Check with a spirit
level.
1. The appliance must stand in a stable and level position to ensure proper
operation.
2. Place a spirit level on the slide-in rail (A) inside the appliance and on the inside of
the appliance door (B / see fig. below) to check if the appliance is level.
3. If necessary, level the appliance by adjusting the three supporting feet individually.
4. The
REAR SUPPORTING FOOT
by adjusting the setscrew (C 1) in the centre of the appliance base using a Phillips
screwdriver (s. fig. below).
5. To adjust the
FRONT SUPPORTING FEET
the front supporting feet until the appliance is level and stable.
When adjusting the supporting feet, pay attention to the arrow directions
indicated on the appliance (raising or lowering the appliance).
The free space between the top of the appliance and the worktop must be
less than 5 mm.
The maximum adjustment height of the supporting feet is 50 mm.
6. When levelling the appliance, ensure that it does not tip over.
H
OW TO LEVEL THE APPLIANCE PROPERLY
can be adjusted from the front of the dishwasher
ROPER LEVELLING
(C 2), use a flat screwdriver and adjust
~ ~
101
.