Tronic Qi TPBQ 10000 A1 Bedienungs- Und Sicherheitshinweise Seite 14

The product should never be charged at a PC or notebook,
because due to the high power consumption, the PC or
notebook could be damaged.
NOTE:
Do not attach a metal object to the Qi charging surface
Do not charge your device when the Qi charging surface
is covered with a towel, layer of dust, etc.
2
Do not allow the Qi charging surface
water, beverages, etc.
Do not use the Qi charging surface
Immediately switch the product off and remove the charging
cable from the product if you smell burning or see smoke.
Have the product examined by a qualified technician before
using it again.
Do not subject the Qi charging surface
forces or impact. Failure to do so may result in damage,
injury and/or malfunction.
Do not place magnetic recording media inside the charging
area during charging. The magnetism generated may erase
the data on credit cards. It may also cause wristwatches and
other precision instruments to malfunction.
During charging and immediately after charging, the Qi
charging surface
normal and not a malfunction. If there is an unusual heating,
check the Qi charging surface
Always place only one mobile device to charge on the Qi
charging surface
time.
Compatibility with all Qi devices cannot be guaranteed.
Do not attach an anti-slip mat or stickers to the Qi charging
surface. The presence of an anti-slip mat or stickers between
the mobile device to be charged and the Qi charging
surface 2
GB/IE/NI 14
2 and mobile device will be warm. This is
. Only one device can be charged at a
2
that may prevent charging start.
to get wet from
2
if it is malfunctioning.
2
2 with a strong
and mobile device.
2
2
.