Initial Set Up; Connection Of Ptfe Handle With Carbon Fibre Brush; Earth Terminal Connection; Locking / Unlocking The Plug - LORCH EC-Clean 1000R Bedienungshandbuch

18

Initial set up

The mains switch must always be switched off
and the cable disconnected from the mains
when working on the unit.
 Connect the mains plug of the device to a suitable 230 V
mains socket.
18.1 Connection of PTFE handle with carbon
fibre brush
1
1
PTFE handle
2
Cable 10 mm "black"
2
3 Insulated plug
‰ The PTFE handle (1) is firmly connected to the black 10
mm cable (2) and the plug (3).
2
 Always insert the plug (3) into the "minus" connection
socket.
18.2

Earth terminal connection

1
1
Earth terminal
2
Cable 10 mm²
3
Plug
‰ A cable with a cross-section of 10 mm² is used for power
transmission.
‰ The mass tongs are made of cast brass, which makes them
very stable and does not scratch the surface of the work-
piece.
‰ The earth terminal establishes the electrical contact be-
tween the workpiece and the electrochemical cleaning
device.
 Ensure a good electrical contact has been established be-
tween the earth terminal and the workpiece.
 Clean the contact point if necessary.
 Always connect the earth plug (1) to the "Plus" connection
socket on the unit.
- 34 -
2
3
2
3
Very high currents flow during cleaning.
– Connect the earth terminal directly to the
18.3

Locking / unlocking the plug

The plugs lock automatically when inserted
i i
into the connection sockets and can only be
unlocked by pressing them in again!
Make sure that the connections are correct.
Locking the plug
 Push the plug into the connector socket until you feel it
clearly engage.
 Check that the plug is seated correctly by pulling it back
slightly.
‰ The plug must not come loose.
Unlocking the plug
 To unlock, press the plug lightly into the connection sock-
et until you feel a resistance (light click).
9 The interlock is released.
 Now pull the plug out of the connection socket.
Never pull the plugs out of the socket by the
cable!
The cables can be damaged.
Never load the plugs crosswise.
909.4609.9-00
Initial set up
workpiece to avoid shunts.
05.22