Bosch PFS 3000-2 Originalbetriebsanleitung Seite 27

Problem Cause
Spray material too viscous
Spray material runs off after Too much spray material applied
coating
Clearance to target area too close
Viscosity of spray material too low
Spray material applied too often over same
spot
Atomisation too coarse Spraying capacity too high
Air flow too low
White nozzle cap (10) mounted (nozzle dia-
meter too large)
Nozzle needle (14) contaminated
Spray material too viscous
Air filter (31) heavily contaminated
Excessive paint mist Too much spray material applied
Air flow too high
Clearance to target area too large
Spray jet pulsates Not enough spray material in container
Ventilation hole (17) on suction tube (16)
clogged
Suction tube (16) loose
Container seal (15) not positioned or not cor-
rectly positioned in groove of suction tube (16)
Nozzle cap (10)/(11) loose
Air filter (31) heavily contaminated
Spray material too viscous
Spray material dripping at Deposit of spray material on the nozzle
the nozzle cap cap (10)/(11), the nozzle needle (14) and the
air cap (2)
Nozzle cap (10)/(11) loose
No spray material coming Sliding switch (25) is in position ◯
out of the nozzle cap
No pressure build-up in container (7) due to
container not being completely closed
Suction tube (16) loose
Nozzle needle (14) clogged
Suction tube (16) clogged
Ventilation hole (17) on suction tube (16)
clogged
Container seal (15) missing or damaged
Spray material too viscous
Bosch Power Tools
Corrective measure
Dilute the spray material again and carry out a
test-spray run
Turn the thumbwheel (4) to setting 1
Increase spray distance
Add original spray material
Remove spray material; reduce number of
spray paths over same spot
Turn the thumbwheel (4) to setting 1
Slide the sliding switch (25) to the right
Fit the grey nozzle cap (11)
Clean nozzle needle
Dilute the spray material again and carry out a
test-spray run
Change air filter
Turn the thumbwheel (4) to setting 1
Slide the sliding switch (25) to the left
Reduce spray distance
Refill spray material
Clean the suction tube and the ventilation hole
Slide the suction tube all the way onto the paint
channel (18)
Mount the container seal precisely all around in
the suction tube groove
Tighten the nozzle cap
Change air filter
Dilute the spray material again and carry out a
test-spray run
Clean the nozzle cap, nozzle needle and air cap
Tighten the nozzle cap
Set the sliding switch to "wood" or "wall" applic-
ation
Turn the container (7) towards the close sym-
bol until you hear the lock ring (6) engage
Slide the suction tube all the way onto the paint
channel (18)
Clean nozzle needle
Clean suction tube
Clean the suction tube and the ventilation hole
Slide a (new) container seal over the suction
tube into the groove
Dilute the spray material again and carry out a
test-spray run
1 609 92A 84D | (12.07.2022)
English | 27