Tests Before Starting The Appliance; Putting On The Carrying Strap - Grizzly BHS 25 L Originalbetriebsanleitung

Table of fuel mixtures:
Petrol Grizzly two-stroke oil
3,00 litres
4,00 litres
5,00 litres
40 parts of petrol + 1 part
Mixing
• Do not use undiluted fuel. Only use
two-stroke oil (no four-stroke oil or oil
for water-cooled engines). Non-com-
pliance may damage the motor and
your warranty will be voided.
1. Prepare the petrol/oil mixture
in a clean canister intended for
use with petrol.
2. First fill in half of the petrol, then
all of the oil, then shake the
canister. Fill in the rest of the
petrol and shake the canister
again.
D
3. Remove the filler cap and fill the
fuel mixture into the petrol tank.
Wipe spilled fuel from around
the filler opening and replace
the filler cap.
Tests before starting the
appliance
• Verify that the spark plug connector
is attached properly. A lose connector
may produce sparks that might ignite
any fuel-air mixture escaping.
• Verify that all switches move freely and
that the safety devices are operative.
• Verify that the blade is mounted prop-
erly and that the handles are clean.
• Verify that there is enough fuel in the
tank and fill up as necessary.
75 ml
100 ml
125 ml
of oil
Swivel the blade bar
E
1. Hold the safety blade beam
A
( 1) on the handle to adjust
the blade beam (6).
2. Pull the locking lever fixing (4)
out of the locking lever (5a).
3. Unlock the stop lever (5a) by
pressing the safety lever (5b).
Press simultaneously on the
safety lever (5b) and stop lever
(5a) to release the safety blade
beam fixing (
4. The safety blade beam (
can now be swivelled out into
the operating position. Use the
stop stages and allow the stop
lever (5a) and safety lever (5b)
to click back in.
5. The locking lever fixing (4)
automatically clicks into the
locking lever (5a).

Putting on the Carrying Strap

Always wear a shoulder strap
when working with the equipment.
Always switch off the equipment
before loosening the shoulder
strap. Risk of accidents.
F
1. Put on the carrying strap (26) and
close the belt buckle (33).
2. Adjust the strap so it fits tightly.
3. Adjust the strap so the spring clip (34) is
around 10 cm below the hip.
4. Fix the spring clip onto the lifting ring (14)
on the shaft tube of the equipment.
The carrying strap is provided with
a quick release. The spring clip
(34) can be released or attached
by pulling out / pushing in the metal
catch (36) found on the red band
GB
A
1).
A
1)
93