Special Functions
Auto Start (Timer-Function)
The maximum time-delay is 23 hours and 59 minutes.
NOTE:
• First set the clock! Otherwise you may not use this function.
• When using auto start, the defrost function is not available. This
program setting does not support quick start cooking.
Example: It is 10:45 o'clock. You want to program the microwave so
that it operates at maximum power for 7 ½ minutes at 14:20 o'clock.
Proceed as follows for automatically starting the microwave:
Step
Button
1
MICROWAVE
2
START / +30SEC. / CONFIRM
3
4
CLOCK / PRE-SET
5
6
CLOCK / PRE-SET
7
8
START / +30SEC. / CONFIRM
NOTE:
• During this programmed setting the functions of the controls are
blocked (except: CLOCK / PRE-SET and STOP / CLEAR).
• If you wish to display the start time again, press the CLOCK /
PRE-SET button.
• When the pre-set time has been reached, the microwave will start
operation. Two signal tones will indicate the start.
WARNING: Risk of Fire!
• Always supervise the appliance during operation.
• When using the time-delay function, set the time in such a way that
the appliance will be operating under proper supervision.
• Do not operate the microwave empty.
• If you want to take out the food before the program has finished,
you have to cancel the program by pressing the STOP / CLEAR
button.
Locking (Child-proof Lock)
• Press and hold the STOP / CLEAR button for 3 seconds to lock the
appliance. The display will show the locked setting. The control panel
function is blocked.
• Press and hold the STOP / CLEAR button again for 3 seconds to
unlock.
Display Function
• During microwaving, grilling, combined or hot air operation (without
preheating) you can press the MICROWAVE, GRILL / COMBI. or
CONVECTION button for 2 – 3 seconds in order to show the current
mode or temperature level.
• In disregard to the operation mode, the display will be showing the
current time for 2 – 3 seconds when pressing the CLOCK / PRE-SET
button.
• During time-delay mode, press the CLOCK / PRE-SET button to
display the start time.
26
MWG2216H_EB_IM_new5
Display
(Power selection)
(Confirm)
(Cooking time)
(Current time)
(Set hour)
(Confirmation of hour)
(Setting the minutes)
(Current time)
Cleaning
WARNING:
Turn the microwave off and remove the mains plug.
CAUTION:
• Do not use any wire brush or other abrasive objects.
• Do not use any acidic or abrasive detergents.
• Do not use a metal scraper to clean the viewing window. The sur-
face could be scratched and the glass could possibly break.
Interior
• Keep the interior of the oven clean. Splashes and overflowing liquids
on the walls of the oven can be removed with a damp cloth. If the
oven is very dirty a mild detergent can also be used.
• Wipe off the viewing window on the inside and outside with a damp
cloth and remove splashes and stains from overflowing liquids regu-
larly.
External Walls
• The external walls of the microwave should only be cleaned with a
damp cloth. Please ensure that no water enters the openings in the
housing and therefore inside the appliance.
• Open the microwave door before cleaning the control panel in order
to avoid accidentally switching on the appliance.
Accessories
• Clean the glass plate in warm soapy water or in the dishwasher. Dry it
before reinstalling it in the microwave.
• Regularly clean the guide ring and the inside of the bottom. You may
remove the guide ring and manually clean it. Use a mild detergent or
glass cleaner. Dry thoroughly. Make sure to position the ring properly
afterwards.
• Clean the grill after each use with a washing-up liquid or place it in a
dishwasher for cleaning.
Odours
In order to remove any unpleasant odours that may emanate from the
microwave, place a dish filled with water and lemon juice that is suitable
for microwave use in the oven and heat it for approximately 5 minutes.
Then wipe out the oven with a soft cloth.
Oven Light
If you need to replace the lighting in the oven, please contact a special-
ist workshop near you.
Troubleshooting
Malfunctions are often just caused due to minor problems. Before con-
tacting our customer service, please check the table below:
Problem
Possible Cause
Radio or TV
The electromagnetic
reception is
fields of this appliance
interrupted dur-
might interfere with the
ing microwave
pictures and sound of
operation.
special frequencies.
The appliance
Defect wall socket.
is not supplied
with electricity;
the display is
black.
Notes / Solution
This is normal and not a
malfunction. Position the
appliances further away
from each other.
Try another wall socket.
Check the main fuse in
your household.
03.08.21