OPERATION INSTRUCTIONS
Attempt to use the air conditioner under the temperature beyond the specified range may cause
the air conditioner protection device to start and the air conditioner may fail to operate. Therefore,
try to use the air conditioner in the following temperature conditions.
Fixed air conditioner:
MODE
Temperature
Room temperature
Outdoor temperature
Inverter air conditioner:
MODE
Temperature
Room temperature
Outdoor temperature
With the power supply connected, restart the air conditioner after shutdown, or switch it to other
mode during operation, and the air conditioner protection device will start. The compressor will
resume operation after 3 minutes.
Characteristics of heating operation (applicable to Heating pump)
Preheating:
When the heating function is enabled, the indoor unit will take 2~5 minutes for preheating, after
that the air conditioner will start heating and blows warm air.
Defrosting:
During heating, when the outdoor unit frosted, the air conditioner will enable the automatic
defrosting function to improve the heating effect. During defrosting, the indoor and outdoor fans
stop running. The air conditioner will resume heating automatically after defrosting finish.
Emergency button:
Open the panel and find the emergency button on the electronic control box when the remote
controller fails . (Always press the emergency button with insulation material.)
Current status
Standby
Standby
(Only for heating pump)
Running
Heating
0
~
27
-7
~
24
Heating
0
~30
-15
~30
(Low temperature
heating: -25 ~30
Operation
Press the emergency button
once
Press the emergency button
twice in 3 seconds
Press the emergency button
once
13
Cooling
17
T1 climate: 15
T3 climate: 15
Cooling
17
T1 climate: 15 ~53
(Low temperature cooling: -15
)
T3 climate: 15
Respond
It beeps briefly once.
It beeps briefly twice.
It keeps beeping for a while
(open the panel of indoor unit)
Dry
~
32
~
43
~
52
Dry
~
32
~53 )
~
55
Enter mode
Cooling mode
Heating mode
Off mode
control-box cover