2. Fasten the control handle (b) on the tube (C) placing it in a vertical position.
Secure the position of the handle by tightening the clamping screw on its
bracket. Caution: The control handle cable cannot be twisted or wrapped
around the tubes!
3. Assemble the remaining tubes by inserting them into each other and twisting
until they lock into place.
ADJUSTING THE BACKPACK STRAPS
Put the backpack with the blower on. The picture below shows you how to adjust
the harness. Pull down to shorten the length of the harness. Lift tabs to lengthen
the harness.
ADJUSTING THE CONTROL HANDLE
After putting the backpack with the blower on, adjust the position of the control
handle to match its length to the length of your arms.