Skil GM1 0150 Serie Originalbetriebsanleitung Seite 11

a
Brushless cordless lawn mower
INTRODUCTION
This tool is intended for domestic lawn mowing only
•
• This tool is not intended for professional use
• Check whether the packaging contains all parts as
illustrated in drawing 3
• When parts are missing or damaged, please contact your
dealer
• Assembly instructions 2
- the sequence of the numbers appearing in the drawing
corresponds with the sequence of the steps to be
followed for assembling the lawn mower
• Read this instruction manual carefully before use
and save it for future reference 4
TECHNICAL DATA 1
TOOL ELEMENTS 3
A Safety switch
Trigger switch
B
C Motor control cable
D Telescopic handle
Handle lock
E
F Quick release // adjustable working height
G Central handle for height adjustment
Battery cover
H
J Grass box
K Self propelling lever
L Transport handle
Speed dial
M
N Mulching plug
P Safety key
Q Battery level indicator
R Grass box full indicator
SAFETY
GENERAL
• Never allow children or people unfamiliar with these
instructions to use the tool
• This tool is not intended for use by children and persons
with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge
• Ensure that children do not play with the tool
Local regulations may restrict the age of the operator
•
• Avoid operating the mower on wet lawns
• The user is responsible for accidents or hazards
occurring to other people or their property
• Never operate the tool with a defective rear guard or
defective grass box
• When operating the tool without grass box, ensure
that the rear guard is in closed position (risk of injury
caused by rotating cutting blade)
• Always switch off the tool, remove battery pack, and
ensure that all moving parts have come to a complete
standstill
- whenever leaving the tool unattended
- before clearing jammed material
- before checking, cleaning or working on the tool
- after striking a foreign object
- whenever the tool starts vibrating abnormally
• If the cutting mechanism strikes any foreign object or
0150
if the tool should start making any unusual noise or
vibration, immediately switch off, allow the cutting blade
to stop, disconnect the plug and take the following steps
- inspect for damage
- replace or repair any damaged parts
- check for and tighten any loose parts
PERSONAL SAFETY
• Do not operate the tool when barefoot or wearing open
sandals; always wear sturdy shoes and long trousers
• Avoid wearing clothing that is loose fitting or that has
hanging cords or ties
• Be familiar with the controls and the proper use of the
tool
• Never mow in the direct vicinity of persons (especially
children) and animals
• Always keep hands and feet away from rotating
parts
• Keep away from the discharge opening at all times
Switch on the motor according to instructions and with
•
feet well away from the cutting blade
• Operate the mower at a walking pace only (do not run)
• Keep proper footing on slopes and do not mow extremely
steep slopes
• Be extremely careful when moving backwards or pulling
the mower towards you
• Be careful during adjustment of the machine to prevent
entrapment of the fingers between moving blades and
fixed parts of the machine
BEFORE USE
• Check the functioning of the tool before each use and,
in case of a defect, have it repaired immediately by a
qualified person; never open the tool yourself
• Thoroughly inspect the area where the mower is to be
used and remove all hard objects which could be caught
up and thrown by the cutting mechanism
• Always ensure that the cutting mechanism is in good
working order (have worn or damaged parts replaced)
• Keep all nuts, bolts and screws tight to be sure that the
tool is in a safe working condition
DURING USE
• Only mow with sufficient daylight or with appropriate
artificial lighting
• Do not tilt the tool when starting or switching on the
motor, except if the tool has to be tilted for starting in
long grass (in this case, do not tilt it more than absolutely
necessary and tilt only the part which is away from the
operator); always ensure that both hands are in the
operating position before returning the tool to the ground
• Ensure that the cutting blade is at a complete standstill
when tilting the tool for crossing surfaces other than
grass and when transporting it to and from the area to be
mowed
• Mow across the face of slopes (never up and down)
• Be extremely careful when changing direction on slopes
• Never pick up or carry the lawn mower while the motor
is running
• Never use the tool when handle cord is damaged, have it
replaced by a qualified person
AFTER USE
• Always allow the tool to cool down before storing
• Store the tool indoors in a dry and locked-up place, out
of reach of children
- store the battery pack separately from the tool
11