Unpacking And Positioning; Unpacking The Machine; Machine Positioning - Sanremo YOU YO1A 0 0 C Serie Betriebsanleitung

Transport, unpacking and components
TRANSPORT, UNPACKING AND
5

UNPACKING AND POSITIONING

IMPORTANT: unpacking and
positioning operations must be
performed by a specialized and
authorized technician.
In order to prevent risks of
contamination, we recommend
unpacking the equipment only when
it is installed.

5.1 UNPACKING THE MACHINE

- The following operations must be performed by at
least two operators;
- Always check the conditions of the package:
inform the carrier if damaged;
- Open the top of the package and lower the tabs;
- Pull out the accessories: supplies and technical
documentation (manuals);
- Loosen the four locking devices;
- Lift the top part;
- Open the cellophane and lift the machine
HOLDING IT BY ITS BASE;
- The elements of the package (box, cellophane,
metal staples, etc.) can cut or injure if not handled
with care or used improperly; keep away from the
reach of children or unsuitable persons.
ATTENTION: packaging elements
(plastic bags, cardboard, nails, etc.)
must NOT be left within the reach of
children as they may be source of
danger.
Any damage, malfunction or
non-conformity must be timely
communicated, in any case within
8 days from receipt of the machine.
Otherwise the goods are deemed
accepted.
COMPONENTS

5.2 MACHINE POSITIONING

Position the machine in its final location, checking
that:
1. the support cabinet is sufficiently sturdy and stable,
2. there are at least 10 cm between the rear wall of
3. the top part of the machine (cup heating plate) must
4. prepare an electrical panel, a water drain and
5. do not use or install in locations where water jets
6. to ensure normal operation, the device must be
63
considering the machine weight, well levelled, dry
and smooth and positioned at a height of more than
90 cm above the ground;
the machine and the walls of the room, to allow
proper ventilation;
be at a height of not less than 150 cm from the floor;
a water supply tap near the machine for water
connection;
are used;
installed in places where the temperature is between
+ 5°C and + 32°C and the humidity does not exceed
70%. If the machine is exposed to temperatures
below + 0°C, proceed as follows: make sure that
the machine has been stored for 24 hours in a place
where the temperature is above + 15°C before
switching on. The machine is electrically powered.
YOU