General; Designated Use - Selve iveo WS Betriebsanleitung

GB General

2. General

The iveo Sensor WS/WSRF is transmitting on the iveo frequency 868 MHz and can only
be operated with iveo and intronic compatible products. These values can be set via
the i-R Marki Send WS and i-R Marki Send Plus.
The iveo Sensor WS measures the surrounding wind speed and brightness. The iveo
Sensor WSRF registers humidity (rain) and temperatures (frost) additionally. The mea-
sured values are transmitted to one or more receivers (e.g. motors of awnings, roller
shutters, venetian blinds or flush-mounted receivers) via radio. Depending on the pre-
setting of the receivers these will automatically be retracted and extended.
The iveo Sensor WS/WSRF needs the mains voltage 230 V ~ for operation.

2.1. Designated use

The iveo Sensor WS/WSRF may only be connected via radio with SELVE iveo or
intronic compatible devices.
• Please note that radio sets cannot be operated in areas with increased risk of interfer-
ence (e.g. hospitals, airports).
• The remote control is only permitted for equipment and systems with which a mal-
function in the hand-held transmitter or receiver does not present a risk to persons,
animals or objects, or this risk is covered by other safety devices.
• The operator does not enjoy any protection from disturbances by other remote signal-
ling equipment and terminal equipment.
• The radio receiver may only be connected to devices and systems that are approved
by the manufacturer.
16