Viper AS380/15B-EU Betriebsanleitung Seite 7

3 Turn on the main switch (47).
．
4 Turn on the brush motor switch (48) and the solution switch (50), the indicate light will be on.
．
5 Turn on the vacuum motor switch (49), the indicate light will be on.
．
6 If necessary, adjust the water flow by turn the ball valve (31) manually
．
7 Pull one or both operating triggers (24), and then brush will start to spin, solution will begin to flow.
．
Move the machine and start cleaning,
Before lifting the brush, turn it off by pressing the switch (47).
After scrubbing, please proceed with below actions before leaving the machine:
1 Remove the brush/pad-holder.
．
2 Empty the tanks as shown in the previous parsagraph.
．
3 Perform the daily maintenance procedures (see the maintenance chapter)
．
4 Store the machine in a clean and dry place, with the brush/pad-holder and the squeegee
．
5 If storing in an area which may reach freezing temperatures, be sure to drain all fluids from the
．
machine prior to storage. any damage caused by freezing temperatures will not be covered by the
warranty.
If the machine is not going to be used for more than 30days, please proceed with below actions:
1. Perform the procedures shown in 'After Using the Machine paragraph'.
2. Disconnect the battery connector.
The lifespan of the machine and its maximum operating safety are ensured by correct and regular
maintenance. The following chart provides the scheduled maintenance. The intervals shown may vary
according to particular working conditions, which will be defined by the person in charge of the
maintenance.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel, or by
！
！
！