Viper AS380/15B-EU Betriebsanleitung Seite 14

Trouble
The machine does not
indicator light (51) do not turns on
The machine does not
indicator light(51) display red
Brush motor does not work, brush
indicator light (52) do not turns on
Brush motor does not work, brush
indicator lights (52) flash
Vacuum system motor does not
work, vacuum motor indicator light
(53) do not turns on
Vacuum system motor does not
work, brush indicator lights (53)
flash
The suction power is insufficient
The solution flow is insufficient.
The squeegee leaves marks on the
floor.
Possible Cause
work, The battery connector is disconnected
The batteries are completely discharged
The power line disconnected from the
power
work, The batteries are discharged
The PCB or key board is faulty
The deck motor is overloaded
There are foreign
threads,etc)preventing the brush from
rotating
The PCB or key board is faulty
The vacuum system motor is overloaded
The recovery tank is full.
The hose is disconnected from the
squeegee
Vacuum assembly is clogged
The squeegee is dirty, or the squeegee
blades are worn or damaged
The recovery tank do not limited
The tank cover is not properly closed, or
the gasket is damaged
The solution filter is dirty
The solution is empty
Solution flow control valve(31) is block
up
The solution is dirty
There is debris under the squeegee blades
The squeegee blades are worn, chipped
or torn
Remedy
Connect
Charge the batteries
Connect
Charge the batteries
Change the PCB or key board
Use
suitable for the floor to be cleaned
materials(tangled Clean the brush hub
Change the PCB or key board
Check the vacuum system motor
Empty the recovery tank.
connect
Clean or check
Clean and check the squeegee
Lock the latch(17)
Close the cover properly or
replace the gasket
Clean the filter
Fill the tank
Clean the valve
Empty the solution, clean the tank
and refill with clean solution
Remove the debris
Replace the blades
less aggressive brushes